Effect changing switch VLAN ID on switch access port on standlaone access point

buro_1986 — Mon, 05 Jul 2021 17:12:21 GMT

I need some guidance on wireless. I am working on a customer where the there are many standalone access points. Currently the customer is running only VLAN 1 in its network. Now they want to move to remove VLAN 1. I am going to change vlan ID from 1 to 111. I am in doubt whether ap will work or not with this change.

Do i need to make any change on AP regarding the native VLAN. Current configuration on AP is as below:-

!
interface BVI1
ip address 10.76.49.49 255.255.240.0
no ip redirects

!
bridge irb
!

!
interface Dot11Radio0
no ip address
no ip redirects
no ip unreachables
no ip proxy-arp
no ip route-cache
!
encryption key 1 size 128bit 7
encryption key 2 size 128bit 7
encryption key 3 size 128bit 7
encryption key 4 size 128bit 7
encryption mode wep mandatory
!
ssid WLANIndust_2010
!
station-role root
no cdp enable
bridge-group 1
bridge-group 1 subscriber-loop-control
bridge-group 1 block-unknown-source
no bridge-group 1 source-learning
no bridge-group 1 unicast-flooding
bridge-group 1 spanning-disabled
!

!
dot11 ssid WLANIndust_2010
authentication open mac-address mac_methods
infrastructure-ssid optional

!
interface FastEthernet0
no ip address
no ip redirects
no ip unreachables
no ip proxy-arp
no ip route-cache
duplex auto
speed auto
bridge-group 1
no bridge-group 1 source-learning
!

Re: Effect changing switch VLAN ID on switch access port on standlaone access point

Seb Rupik — Fri, 05 Apr 2019 08:25:03 GMT

Hi there,

Your AP is not configured to send or receive tagged frames on Fa0/0, it will be totally oblivious to you changing the VLAN ID on the switch it is connected to.

cheers,

Seb.

topic Effect changing switch VLAN ID on switch access port on standlaone access point in Wireless

Effect changing switch VLAN ID on switch access port on standlaone access point

Re: Effect changing switch VLAN ID on switch access port on standlaone access point