Cannot change Redundancy Management port number

stephendrkw — Mon, 05 Jul 2021 14:05:26 GMT

has anyone come across this before, I would like to change the RP management port# to something else i.e port 4 and the following message appears! I wondering why and why this cannot be changed. Is the default port 1?

(wcon) >config interface port redundancy-management 4

Changing the redundancy-management port is not allowed

(wcon) >show redundancy sum
Redundancy Mode = SSO DISABLED
     Local State = ACTIVE
      Peer State = N/A
            Unit = Primary

) >show interface sum

Number of Interfaces.......................... 8

Interface Name                   Port Vlan Id IP Address      Type    Ap Mgr Guest
-------------------------------- ---- -------- --------------- ------- ------ -----
management                       1    202      10.x.x.x     Static Yes    No
redundancy-management            1    202      10.x.x.x.     Static No     No
redundancy-port                  -    untagged 169.254.110.4   Static No     No
n
service-port                     N/A N/A      10.x.x.x Static No     No
virtual                          N/A N/A      1.1.1.2         Static No     No

I think I have solved it..

stephendrkw — Tue, 23 May 2017 08:42:40 GMT

I think I have solved it...but I'll leave the discussion open.

Because the RP uses an IP address in the same subnet as the Management port, the configuration binds 2 IP addresses to the port? Therefore whatever port the Management port uses it will copy this port config to RP?

topic Cannot change Redundancy Management port number in Wireless

Cannot change Redundancy Management port number

I think I have solved it..