topic Hi Rasika, that's for in Wireless

CMX10.2 firstboot

mariusst — Mon, 05 Jul 2021 12:07:21 GMT

I want to setup my CMX 10.2 from scratch and enetered the cmxos firstboot command to achieve that , but that does not seem to do anything.

[root@localhost cmxadmin]# cmxos firstboot --force
********************************************************************************
** Welcome to Cisco CMX
** This setup procedure will take you through configuring your CMX.
** Please press the enter key to continue...

*** The system is already configured

You have successfully upgraded and configured CMX. Please use the command 'cmxctl start'

Is there another command I should run ?

hi Marius, we have the same

Frank Vergeer — Wed, 19 Apr 2017 13:44:19 GMT

hi Marius, we have the same situation (in version 10.3) Have you found a solution for this issue? we want to reconfigure an already installed MSE/CMX appliance

Hi Frank,

Rasika Nayanajith — Thu, 20 Apr 2017 03:59:30 GMT

Hi Frank,

Did you try "cmxos reconfigure" CLI command

http://www.cisco.com/c/en/us/td/docs/wireless/mse/10-2/cmx_command/guide/cmxcli10/commands.html#14452

HTH

Rasika

*** Pls rate all useful responses ***

Hi Rasika, that's for

Frank Vergeer — Thu, 20 Apr 2017 06:24:01 GMT

Hi Rasika, that's for reconfiguring tcp/ip related settings. I want to reconfigure services (instead of doing a new fresh deployment with ISO image)

I want to reconfigure

Rasika Nayanajith — Thu, 20 Apr 2017 06:36:48 GMT

 I want to reconfigure services (instead of doing a new fresh deployment with ISO image)

What exactly you need to achieve ?

reconfigure "location" services to "presence" or vice versa. If that is the case, you can't do it. Only way is a fresh install

HTH

Rasika

Thanks for the confirmation,

Frank Vergeer — Thu, 20 Apr 2017 08:52:25 GMT

Thanks for the confirmation, I will do a fresh install. This command was new for me and according to the docs it looked like it was possible to reconfigure services by excecuting this CLI command.