WGB config

dave dave — Mon, 05 Jul 2021 10:58:22 GMT

hi! I've a wlc with a few light weight APs setup, and the client get connected and authenticated to the lightweight AP through the WLC's Win NPS server. I would like to setup a new autonomous AP with WGB configuration (with the autonomous connected to a hub, with 2 PC connected), and able to connect to existing Lightweight AP. Need some advise on how to set up the WGB in the autnomous AP. The WLC security configuration is shown in the screenshot attached. Thanks.

I tried this config, but was not successful.

dot11 ssid wgbtest
   vlan 10
   authentication open eap eap
   authentication network-eap eap
   dot1x credentials wgb
   dot1x eap profile eapfast
   infrastructure-ssid
!
!
!
eap profile eapfast
method fast
!
!
!
dot1x credentials wgb
username test\testuser
password 7 xxxxxxx
!
interface Dot11Radio0
no ip address
!
encryption mode ciphers aes-ccm tkip
!
ssid wgbtest
!
antenna gain 0
stbc
station-role workgroup-bridge

workgroup-bridge client-vlan 15

topic WGB config in Wireless

WGB config

Below should helps youhttp:/