topic DCA is taken care by in Wireless

Refreshing DCA AP list.

spencerondrusek — Mon, 05 Jul 2021 09:51:39 GMT

Hi,

How does one refresh an APs DCA from the controller? I removed an interferer and all my APs on the corresponding map do not use that channel (channel 6). I have tried restarting all of the APs.

Here is what the AP sees with show ap auto-rf 802.11b

Nearby APs
AP 00:3a:98:89:72:d0 slot 0.................. -71 dBm on 1 (10.48.193.252)
AP 00:3a:98:94:f3:b0 slot 0.................. -74 dBm on 1 (10.48.193.252)
AP 1c:de:a7:ee:71:90 slot 0.................. -84 dBm on 1 (10.48.193.252)
AP 44:ad:d9:f0:50:40 slot 0.................. -94 dBm on 1 (10.48.193.252)

Any help would be appreciated

There may not be much of a data rate loss but my interband roams sometimes cause an interruption to VoIP service.

Thanks

DCA is taken care by

Saurav Lodh — Thu, 09 Apr 2015 13:33:38 GMT

DCA is taken care by controller, it uses the algo. to dynamically assigning the channels. It uses the sw- decision metrics to come out with the results.

Yes but it is doing it

spencerondrusek — Mon, 13 Apr 2015 17:12:21 GMT

Yes but it is doing it incorrectly because of an interferer that I removed. How do I cause get it to reassign channels?

DCA run at intervals you

Rasika Nayanajith — Tue, 14 Apr 2015 03:01:55 GMT

DCA run at intervals you configured (by default every 10 min) if you set it to Auto. If you want to invoke channel update once, you can select Freeze & Invoke channel update once option as shown below.

HTH

Rasika

**** Pls rate all useful responses ****