topic Thanks for your answer in Wireless

4x4 MIMO

Jorge Emmanuel Hidalgo Vega — Mon, 05 Jul 2021 09:05:54 GMT

Hello

Guys

I have an antenna 3702i of Cisco.

The problem is this:

How can I know 4 Tx and 4 Rx Antennas works in Access Point?? , I think that exists a command or something like this.

Thank you so much for your answer

Regards

Hi

Rasika Nayanajith — Tue, 09 Dec 2014 04:57:40 GMT

If you get the "show controllers dot11radio x" output you can verify that 4-RX & 4-Tx antenna being used.

Configured TxPower:             23 dBm (Level Index 1)
Allowed Power Levels:           23 20 17 14 11  8  5  2  dBm
Allowed Client Power Levels:    23 20 17 14 11  8  5  2  dBm
Antenna:                        Rx[a b c d ]
                                Tx[a b c d  cck all ofdm all]
                                Internal

TEST-AP#sh controllers dot11Radio 1

Configured TxPower:             11 dBm (Level Index 5)
Allowed Power Levels:           23 20 17 14 11  8  5  2  dBm
Allowed Client Power Levels:    23 20 17 14 11  8  5  2  dBm
Antenna:                        Rx[a b c d ]
                                Tx[a b c d  ofdm all]
                                Internal

HTH

Rasika

**** Pls rate all useful responses ****

Thanks for your answer

Jorge Emmanuel Hidalgo Vega — Tue, 09 Dec 2014 23:28:15 GMT

Thanks for your answer Manannalage ras =D