topic Resetting AP1131 in Wireless

Resetting AP1131

technician2 — Mon, 05 Jul 2021 08:38:57 GMT

We have an AP1131 access point which was installed by a previous technician. He left, without leaving the password details!

So I performed a Factory Reset, using the Mode button, as per the manual.

Hold down the Mode button
Re-insert the PoE injector
Wait for the Ethernet light to go orange
Stop pressing the Mode button

The unit then re-initialises, the Ethernet light goes green but the Radio light doesn't come on.

What do I need to do?

Regards

Adrian

Hi Arian,Since you reset to

Rasika Nayanajith — Mon, 06 Oct 2014 08:54:38 GMT

Hi Arian,

Since you reset to factory defaults there may not any configuration on it. So without SSID configuration radio interface may not come up.

You have to console in to this to configure it using CLI. Otherwise you can try to access it via GUI using the default IP address (credential should be Cisco/Cisco)

HTH

Rasika

**** Pls rate all useful responses ****

You would have to reconfigure

Moin Ilyas — Thu, 09 Oct 2014 00:07:25 GMT

You would have to reconfigure the AP using the default IP Address or console into the AP.