topic WiSM2 status keepalive in Wireless

WiSM2 status keepalive

mlieber — Sun, 04 Jul 2021 08:03:32 GMT

we have installed new WiSM2 in Cat6500 and both WiSM are in status "started keepalive".

DESTGSW001#sh wism status

Service Vlan : 192, Service IP Subnet : 192.168.250.65/255.255.255.248

WLAN

Slot Controller Service IP Management IP SW Version Controller Type Status

----+-----------+----------------+----------------+------------+------------------+---------------

1 1 192.168.250.67 0.0.0.0 WS-SVC-WISM-2-K9 Started KeepAlive

But everything else looks fine,

Access Points are joined, client are connected and HA redundancy is also working fine.

The WiSM service-ports gets the IP address from DHCP server

The WiSM2 has software

Manufacturer's Name.............................. Cisco Systems Inc.

Product Name..................................... Cisco Controller

Product Version.................................. 7.5.102.0

Bootloader Version............................... 1.0.16

Field Recovery Image Version..................... 7.0.112.21

Firmware Version................................. FPGA 1.7, Env 0.0, USB console 2.2

Build Type....................................... DATA + WPS

and Cat6500

Cisco IOS Software, s72033_rp Software (s72033_rp-IPSERVICESK9-M), Version 15.1(1)SY1, RELEASE SOFTWARE (fc5)

Does have anyone any idea?

thanks

Martin

WiSM2 status keepalive

Leo Laohoo — Thu, 10 Oct 2013 21:59:51 GMT

If your output is correct, your WiSM does NOT have any Management IP Address.

WiSM2 status keepalive

mlieber — Fri, 11 Oct 2013 04:54:28 GMT

Hi,

the output is correct.

The management IP address will be visible when the status is "Oper-UP".

WiSM2 status keepalive

mlieber — Fri, 11 Oct 2013 07:39:23 GMT

Hi,

this is the output from WiSM

Interface Name Port Vlan Id IP Address Type Ap Mgr Guest

-------------------------------- ---- -------- --------------- ------- ------ -----

management LAG 300 10.78.200.4 Static Yes No

redundancy-management LAG 300 10.78.200.6 Static No No

redundancy-port - untagged 169.254.198.6 Static No No

service-port N/A N/A 192.168.250.67 DHCP No No

WiSM2 status keepalive

Johan Lindstrand — Fri, 11 Oct 2013 11:28:17 GMT

Check your cat6500 konfig.

Maybe something is wrong with this commands:

wism service-vlan xxx

wism switch 1 module 1 controller 1 allowed-vlan 10-1001,1006-4030,4040

wism switch 1 module 1 controller 1 native-vlan 4021

wism switch 1 module 1 controller 1 qos vlan-based

WiSM2 status keepalive

mlieber — Wed, 16 Oct 2013 12:59:46 GMT

We have done a hardware reset of the WiSM2, and now the stsuts is "Oper-UP" again.

It looks like the very old bug CSCsg59144