topic Re: Interface Threshold Violation in Wireless

Interface Threshold Violation

Nachiappan Nachiappan — Sun, 04 Jul 2021 06:40:46 GMT

Hi Guys,

I have 8 access points and a 5508 series WLC. I am getting the below alerts

Message: Interference threshold violation reported by '802.11b/g/n' interface of AP 'KPAP0000.f4a6', connected to Controller '10.69.186.21'.

Message: Interference changed to acceptable level on '802.11b/g/n' interface of AP 'KPAP0000.1b40', connected to Controller '10.69.186.21'.

On seraching the forum, i found the below details:

Recommended Actions If the interference threshold is configured to be too low, you may need to readjust it to a more optimum value.

Investigate interference sources such as other 802.11 devices in the vicinity of this radio interface

Im my current configuration i have threshold under 802.11a>RRM>general

Profile threshold for traps - 10% [which is the default]

Just wondering is that the value i need to change. Is there any standard optimal value. Or do i need to find out using trail and error.

Thanks

Re: Interface Threshold Violation

Scott Fella — Wed, 06 Mar 2013 05:11:48 GMT

It really depends. You can adjust them until they go away or your fine with the amount of alerts you receive. So the one thing that is mentioned is interference. Have you checked for interferes? Do you have neighboring access points on the 2.4ghz? All these things have an affect in your RF and how these alerts are being generated. So I would try to identify any 2.4 ghz interferes and then play with the threshold value.

Sent from Cisco Technical Support iPhone App

Re: Interface Threshold Violation

maldehne — Wed, 06 Mar 2013 05:43:13 GMT

rather than tuning the threshold values , i will analyze the RF spectrum and identify the source of interference and act accordingly.

Re: Interface Threshold Violation

Nachiappan Nachiappan — Wed, 06 Mar 2013 07:29:56 GMT

Thank you for your reply.