topic cisco 1130 status light flashing orange in Wireless

cisco 1130 status light flashing orange

tmarques87 — Sun, 04 Jul 2021 05:07:12 GMT

hello,

I have a question, I have an ap (cisco 1130) that began to get the status light flashing orange and light Ethernet and radio are off.

I did a factory reset and it was ok ... past 3 days the problem has happened again ...

I changed the ap with a new but the situation remained ...

I tested the wiring and everything is ok.

the switch port is set up correctly

may be what??

problem switch??or problem ap??

cisco 1130 status light flashing orange

Leo Laohoo — Mon, 07 May 2012 22:36:51 GMT

Console into the WAP and restart the WAP. Please post the entire bootup sequence.

cisco 1130 status light flashing orange

tmarques87 — Tue, 08 May 2012 11:46:19 GMT

I leave the logs requested:

Xmodem file system is available.

flashfs[0]: 10 files, 2 directories

flashfs[0]: 0 orphaned files, 0 orphaned directories

flashfs[0]: Total bytes: 15998976

flashfs[0]: Bytes used: 6278144

flashfs[0]: Bytes available: 9720832

flashfs[0]: flashfs fsck took 33 seconds.

Base ethernet MAC Address: 00:23:33:bc:80:4c

Initializing ethernet port 0...

Reset ethernet port 0...

Reset done!

link auto-negotiating....

auto-negotiation takes 1515 milli-seconds to complete

ethernet link up, 100 mbps, full-duplex

Ethernet port 0 initialized: link is up

Loading "flash:/c1130-rcvk9w8-mx"...############################################ ################################################################################ ################################################################################ ######################################################

File "flash:/c1130-rcvk9w8-mx" uncompressed and installed, entry point: 0x3000

executing...

Restricted Rights Legend

Use, duplication, or disclosure by the Government is

subject to restrictions as set forth in subparagraph

Rights clause at FAR sec. 52.227-19 and subparagraph

Software clause at DFARS sec. 252.227-7013.

cisco Systems, Inc.

170 West Tasman Drive

San Jose, California 95134-1706

Cisco IOS Software, C1130 Software (C1130-RCVK9W8-M), Version 12.4(21a)JA2, RELE ASE SOFTWARE (fc1)

Technical Support: http://www.cisco.com/techsupport

Compiled Mon 02-Nov-09 18:17 by prod_rel_team

Proceeding with system init

Proceeding to unmask interrupts

Initializing flashfs...

flashfs[1]: 10 files, 2 directories

flashfs[1]: 0 orphaned files, 0 orphaned directories

flashfs[1]: Total bytes: 15998976

flashfs[1]: Bytes used: 6278144

flashfs[1]: Bytes available: 9720832

flashfs[1]: flashfs fsck took 4 seconds.

flashfs[1]: Initialization complete....done Initializing flashfs.

%Error opening flash:/info (No such file or directory)

This product contains cryptographic features and is subject to United

States and local country laws governing import, export, transfer and

use. Delivery of Cisco cryptographic products does not imply

third-party authority to import, export, distribute or use encryption.

Importers, exporters, distributors and users are responsible for

compliance with U.S. and local country laws. By using this product you

agree to comply with applicable laws and regulations. If you are unable

to comply with U.S. and local laws, return this product immediately.

A summary of U.S. laws governing Cisco cryptographic products may be found at:

http://www.cisco.com/wwl/export/crypto/tool/stqrg.html

If you require further assistance please contact us by sending email to

export@cisco.com.

%Error opening flash:/info (No such file or directory)

%Error opening flash:/c1130-rcvk9w8-mx/info (No such file or directory)cisco AIR -AP1131G-E-K9 (PowerPCElvis) processor (revision B0) with 24566K/8192K bytes of memory.

Processor board ID FCZ1251Q08N

PowerPCElvis CPU at 262Mhz, revision number 0x0950

Last reset from power-on

LWAPP image version 3.0.51.0

1 FastEthernet interface

32K bytes of flash-simulated non-volatile configuration memory.

Base ethernet MAC Address: 00:23:33:BC:80:4C

Part Number : 73-11587-02

PCA Assembly Number : 800-30422-01

PCA Revision Number : B0

PCB Serial Number : FOC124839B0

Top Assembly Part Number : 800-29578-02

Top Assembly Serial Number : FCZ1251Q08N

Top Revision Number : A0

Product/Model Number : AIR-AP1131G-E-K9

% Please define a domain-name first.

Press RETURN to get started!

*Mar 1 00:00:05.947: %LWAPP-3-CLIENTEVENTLOG: Read and initialized AP event log (contains, 120 messages)

capwap_read_version_info: Info file flash:/info not find

*Mar 1 00:00:08.225: %LINK-3-UPDOWN: Interface FastEthernet0, changed state to up

*Mar 1 00:00:08.252: %SYS-5-RESTART: System restarted --

Cisco IOS Software, C1130 Software (C1130-RCVK9W8-M), Version 12.4(21a)JA2, RELE ASE SOFTWARE (fc1)

Technical Support: http://www.cisco.com/techsupport

Compiled Mon 02-Nov-09 18:17 by prod_rel_team

*Mar 1 00:00:08.280: %CAPWAP-5-CHANGED: CAPWAP changed state to DISCOVERY

*Mar 1 00:00:09.225: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthern et0, changed state to down

AP0023.33bc.804c>

*Mar 1 00:00:37.034: %CAPWAP-3-ERRORLOG: Not sending discovery request AP does not have an Ip !!

*Mar 1 00:00:47.034: %CAPWAP-3-ERRORLOG: Not sending discovery request AP does not have an Ip !!

AP0023.33bc.804c>

*Mar 1 00:00:57.034: %CAPWAP-3-ERRORLOG: Not sending discovery request AP does not have an Ip !!

*Mar 1 00:01:07.034: %CAPWAP-3-ERRORLOG: Not sending discovery request AP does not have an Ip !!

*Mar 1 00:01:10.222: %CDP_PD-4-POWER_OK: Full power - NON_CISCO-NO_CDP_RECEIVED inline power source

*Mar 1 00:01:17.034: %CAPWAP-3-ERRORLOG: Not sending discovery request AP does not have an Ip !!

*Mar 1 00:01:27.034: %CAPWAP-3-ERRORLOG: Not sending discovery request AP does not have an Ip !!

AP0023.33bc.804c>

*Mar 1 00:01:37.034: %CAPWAP-3-ERRORLOG: Not sending discovery request AP does not have an Ip !!

*Mar 1 00:01:47.034: %CAPWAP-3-ERRORLOG: Not sending discovery request AP does not have an Ip !!

*Mar 1 00:01:57.034: %CAPWAP-3-ERRORLOG: Not sending discovery request AP does not have an Ip !!

*Mar 1 00:02:07.034: %CAPWAP-3-ERRORLOG: Not sending discovery request AP does not have an Ip !!

I dont understand the logs, but i see :

there is power problem with the power line wap and ip

I report the fault wap???

But already installed another wap and changed the switch port and the problem ended...

cisco 1130 status light flashing orange

Leo Laohoo — Tue, 08 May 2012 23:26:42 GMT

Errrr ...

The bootup shows OK with me. Are you suppose to operate this WAP in controller-based or autonomous?

cisco 1130 status light flashing orange

tmarques87 — Mon, 14 May 2012 17:11:15 GMT

WAP in controller-based

What problems do you think is it?

Re: cisco 1130 status light flashing orange

Scott Fella — Mon, 14 May 2012 17:18:47 GMT

Console into the ap, reboot the ap and post the complete output.

Thanks,

Scott Fella

Sent from my iPhone

cisco 1130 status light flashing orange

tmarques87 — Tue, 15 May 2012 16:48:50 GMT

hello,

I connect the console in to the WAP and then reboot the result of the bootup is as follows:

Xmodem file system is available.

flashfs[0]: 26 files, 8 directories

flashfs[0]: 0 orphaned files, 0 orphaned directories

flashfs[0]: Total bytes: 15998976

flashfs[0]: Bytes used: 6858240

flashfs[0]: Bytes available: 9140736

flashfs[0]: flashfs fsck took 31 seconds.

Base ethernet MAC Address: 00:24:97:6e:2c:e2

Initializing ethernet port 0...

Reset ethernet port 0...

Reset done!

link auto-negotiating....

auto-negotiation takes 10000 milli-seconds to complete

ERROR: timeout waiting for auto-negotiation to complete

ERROR: fail to bring ethernet link up

The system has been encountered an error initializing

ethernet port. You may need to check hardware

The system is ignoring the error and continuing boot.

If you interrupt the system boot process, the following

commands will reinitialize ethernet, tftp, and finish

loading the operating system software:

ether_init

tftp_init

boot

Loading "flash:/c1130-k9w8-mx.124-23c.JZ/c1130-k9w8-mx.124-23c.JZ"...########################################################################################################################################################################################################################################################################################################################################################################################################################################################

File "flash:/c1130-k9w8-mx.124-23c.JZ/c1130-k9w8-mx.124-23c.JZ" uncompressed and installed, entry point: 0x3000

executing...

Restricted Rights Legend

Use, duplication, or disclosure by the Government is

subject to restrictions as set forth in subparagraph

Rights clause at FAR sec. 52.227-19 and subparagraph

Software clause at DFARS sec. 252.227-7013.

cisco Systems, Inc.

170 West Tasman Drive

San Jose, California 95134-1706

Cisco IOS Software, C1130 Software (C1130-K9W8-M), Version 12.4(23c)JZ, RELEASE SOFTWARE (fc1)

Technical Support: http://www.cisco.com/techsupport

Compiled Wed 06-Apr-11 15:01 by prod_rel_team

Proceeding with system init

Proceeding to unmask interrupts

Initializing flashfs...

flashfs[1]: 26 files, 8 directories

flashfs[1]: 0 orphaned files, 0 orphaned directories

flashfs[1]: Total bytes: 15740928

flashfs[1]: Bytes used: 6858240

flashfs[1]: Bytes available: 8882688

flashfs[1]: flashfs fsck took 4 seconds.

flashfs[1]: Initialization complete....done Initializing flashfs.

Radio0 present A506 7100 E8000000 A0000000 80000000 3

Radio1 present A506 6700 E8000100 A0040000 80010000 2