WISM Interface

Johan Lindstrand — Sun, 04 Jul 2021 03:40:48 GMT

Hello

I am having trouble to upgrade our Catalyst 6509 from s72033-ipservicesk9-mz.122-33.SXH4.bin to 72033-ipservicesk9-mz.122-33.SXJ1.bin. I am upgrading because of installation of a WISM2 controller.

The Catalyst configuration is:

--- ----- -------------------------------------- ------------------ -----------

1 10 WiSM WLAN Service Module WS-SVC-WISM-1-K9

2 10 WiSM WLAN Service Module WS-SVC-WISM-1-K9

3 10 WiSM WLAN Service Module WS-SVC-WISM-1-K9

4 6 Firewall Module WS-SVC-FWM-1

5 2 Supervisor Engine 720 (Active) WS-SUP720-BASE

7 24 CEF720 24 port 1000mb SFP WS-X6724-SFP

The problem is with our WISM controllers, when rebooting with the new IOS 122.33.SXJ

The interface configuration in startup-config is erased completely for all WISM interface.

interface GigabitEthernet1/1

description WISM A

switchport

switchport trunk encapsulation dot1q

switchport trunk native vlan 4060

switchport trunk allowed vlan 780-788

switchport mode trunk

no snmp trap link-status

no cdp enable

channel-group 8 mode on

The only way to keep the Interface konfuguration is witch IOS s72033-ipservicesk9-mz.122-33.SXH4.bin.

Regards

Johan

WISM Interface

pcroak — Wed, 07 Sep 2011 13:39:09 GMT

Johan,

We introduced the auto-configuration wism commands starting in 12.2(18)SXF5, and in the SXI code and later (SXJ included) it is now the only way to configure the WISM modules.

If you were previously using the manual port configuration, you will need to migrate to the new set of wism commands:

http://www.cisco.com/en/US/products/hw/modules/ps2706/products_tech_note09186a00808330a9.shtml#config

wism module controller <1/2> native-vlan x

wism module controller <1/2> allowed-vlan x,y,z...

-Patrick Croak

Wireless TAC

topic WISM Interface in Wireless

WISM Interface

WISM Interface