topic Re: LAP-1131 mounting in Wireless

LAP-1131 mounting

gururajan — Sun, 04 Jul 2021 01:09:14 GMT

Hi,

Please suggest any recommendations to be followed in mounting the AP (like wall and ceiling).

Specifically I would like to know any best practices about the minimum height for mounting the AP.

Regards,

Guru

Re: LAP-1131 mounting

jeff.kish — Wed, 14 Oct 2009 18:52:46 GMT

The primary thing to know about mounting the APs is that they should be mounted flush with the ceiling with the LED looking down at the floor. They are not meant to be hung on a wall, though plenty of organizations will do this and experience adequate coverage.

As for minimum height, I wouldn't hang these more than 15-20 feet in the air. But regardless of the ceiling height you want to use, just hang one temporarily and do a site survey to see what kind of coverage you get. The signal propagation is always dependent on the environment and site-specific structure.

Re: LAP-1131 mounting

Leo Laohoo — Thu, 15 Oct 2009 07:52:52 GMT

The 1130 are designed specifically for office environment: large number of cubicles, compactors, corners, offices, etc.

It is recommended to mount the AP from the ceiling with the "Cisco" logo or the "mood ring" facing the clients.

Are you designing the AP for office environment use or factory, theatre or outdoor use?

Re: LAP-1131 mounting

gururajan — Thu, 15 Oct 2009 08:17:23 GMT

Thanks for the response.

I am designing for office environment only but it is a reception block & ceiling height is more than 20ft.

I just need to know how the radiation pattern will be, if i fix it in the wall vertically or fixing in the reception table in 2.5 ft height from the floor (AP facing upwards or sidewards)

Regards,

Guru