topic Re: AP1200 boot failure in Wireless

AP1200 boot failure

vlad110226 — Sat, 03 Jul 2021 21:17:48 GMT

please help..i encountered a boot fail status on my AP 1200 access point. The LED indicator displays 3 amber light. I tried to reset the AP using mode button but i receive no response from the unit. Please advise the next steps to revive my AP. Appreciate your help. Thanks

Re: AP1200 boot failure

a-vazquez — Tue, 10 Jul 2007 20:22:45 GMT

Try using a different image. http://cisco.com/en/US/docs/wireless/access_point/12.2_13_JA/configuration/guide/s13trb.html#wp1048378

Re: AP1200 boot failure

vlad110226 — Wed, 11 Jul 2007 01:50:12 GMT

thanks, but i can't connect my access point thru console port. Even if i tried to press the mode button while i am powering my unit.

Please advise..is it possible that my unit is screwed? 😞

Re: AP1200 boot failure

Scott Fella — Wed, 11 Jul 2007 02:21:42 GMT

It's dead! Time to RMA it.... especially that you can't see anything when consoled into it.

Re: AP1200 boot failure

vlad110226 — Thu, 12 Jul 2007 00:15:30 GMT

yeah, you're right, i am now working on the warranty agreement with the vendor 🙂 thank you..

Re: AP1200 boot failure

vlad110226 — Thu, 12 Jul 2007 00:18:26 GMT

anyway folks, what's RMA?, sorry

Re: AP1200 boot failure

sbhadrav@cisco.com — Fri, 06 Apr 2018 14:46:21 GMT

I suggest you to remove the 802.11g radio and reload. I suspect that the software on the AP does not meet the minimum requirement for the 802.11g radio. You need a minimum of 12.2(13)JA to support 802.11g radio. I suggest you to load 12.2(15)XR.

Please find out if you run VxWorks or IOS. If you still run VxWorks, you need to upgrade to IOS first. Then, you upgrade to IOS 12.2(15)XR.

Please respond if you do not know how to convert from VxWorks to IOS and upgrade to IOS 12.2(15)XR2.