topic Re: Public wlan consult... in Wireless https://community.cisco.com/t5/wireless/public-wlan-consult/m-p/737705#M190239 <HTML><HEAD></HEAD><BODY><P>You would enable "Public Secure Packet Forwarding" (PSPF). </P><P></P><P>PSPF will prevent any device associated with a given AP from accessing (directly) any other associated device through that AP.</P><P></P><P>It's a checkbox in the WebGUI under the SSID screen. </P><P></P><P>It can also be enabled from the CLI, but I don't recall the command, and I don't have access to my references.</P><P></P><P>Good Luck</P><P></P><P>Scott</P></BODY></HTML> Wed, 06 Jun 2007 00:01:58 GMT scottmac 2007-06-06T00:01:58Z Public wlan consult... https://community.cisco.com/t5/wireless/public-wlan-consult/m-p/737703#M190237 <P>Hi, I'm about to buy a Cisco Aironet AP in order to buil up a wlan. Because the network will be public, i need to know how to deny any relation between the computers connected (access to shared folders, ping, map, etc...).</P><P></P><P>In other words, a network with computers thar must not have any relation between them...</P><P></P><P>How can I implement that?</P><P></P><P>sorry about my english.</P><P>rgds</P> Sat, 03 Jul 2021 21:09:26 GMT https://community.cisco.com/t5/wireless/public-wlan-consult/m-p/737703#M190237 garza__84 2021-07-03T21:09:26Z Re: Public wlan consult... https://community.cisco.com/t5/wireless/public-wlan-consult/m-p/737704#M190238 <HTML><HEAD></HEAD><BODY><P>If you implement layer 2 isolation this will prevent any wireless client from Communicating to any other. This feature is often used in a public hotspot situation.</P><P></P><P>Hope this helps</P><P></P><P>Cheers</P><P></P><P>Mark</P><P></P><P>*Pls rate all useful posts</P></BODY></HTML> Tue, 05 Jun 2007 21:47:38 GMT https://community.cisco.com/t5/wireless/public-wlan-consult/m-p/737704#M190238 DigitalAirWireless 2007-06-05T21:47:38Z Re: Public wlan consult... https://community.cisco.com/t5/wireless/public-wlan-consult/m-p/737705#M190239 <HTML><HEAD></HEAD><BODY><P>You would enable "Public Secure Packet Forwarding" (PSPF). </P><P></P><P>PSPF will prevent any device associated with a given AP from accessing (directly) any other associated device through that AP.</P><P></P><P>It's a checkbox in the WebGUI under the SSID screen. </P><P></P><P>It can also be enabled from the CLI, but I don't recall the command, and I don't have access to my references.</P><P></P><P>Good Luck</P><P></P><P>Scott</P></BODY></HTML> Wed, 06 Jun 2007 00:01:58 GMT https://community.cisco.com/t5/wireless/public-wlan-consult/m-p/737705#M190239 scottmac 2007-06-06T00:01:58Z