AP1130AG default mode

samirss — Sat, 03 Jul 2021 20:13:30 GMT

What is the default mode for AP1131AG,Autonomous or Lightweight Mode.

I am using WLAN controller 4402.

Thanks

Re: AP1130AG default mode

Rob Huffman — Sun, 12 Nov 2006 02:04:48 GMT

Hi Samir,

It depends on the part #. The Cisco Aironet 1130AG Series may be ordered with Cisco IOS Software to operate as an autonomous AP or with Lightweight Access Point Protocol (LWAPP). Check out the part numbers (Note LAP1131AG for lightweight).

AIR-AP1131AG-x-K9 Cisco IOS Software 802.11a/g Non-modular IOS AP; Integrated Antennas

AIR-LAP1131AG-x-K9 LWAPP 802.11a/g Non-modular LWAPP AP: Integrated Antennas

From this doc;

http://www.cisco.com/en/US/products/ps6087/products_data_sheet0900aecd801b901c.html

If you ended up with the Autonomous AP, it can be converted to LWAPP using the LWAPP conversion tool.

Hope this helps!

Rob

Please remember to rate helpful posts.....

topic Re: AP1130AG default mode in Wireless

AP1130AG default mode

Re: AP1130AG default mode