topic The credentials pass always in Wireless

Prime fails to add a WLC

joseavalero — Mon, 05 Jul 2021 09:40:37 GMT

WLC 5508 8.0.115 fails when add to prime 2.2: Unable to collect details neighbor device using Cisco Discovery Protocol. Posible cause :

SNMP request timed out. Verify device credentials and SNMP response speed from device. The SNMP credentials are corrects.

Capturing packets we see that the WLC responds snmp requests but prime does not know how interpret the responses and re-order them.

When you test and verify the

Scott Fella — Tue, 10 Mar 2015 12:48:03 GMT

When you test and verify the credentials on PI 2.2, does both show as pass? The controller and PI seperate across the WAN or are the local to each other? Are you using smnp v3 by chance?

-Scott

The credentials pass always

joseavalero — Wed, 11 Mar 2015 07:48:14 GMT

The credentials pass always previous test, the controller and Prime are in a local network. I tried with snmp version 2c and 3.

Are you using both management

Saurav Lodh — Thu, 12 Mar 2015 20:51:16 GMT

Are you using both management and dynamic (an interface of WLC with an IP address on the same VLAN as Prime Infrastructure) ? If So due to asymmetric routing, it may happen PI will face issue in communicating.

Hi Josè, have you solved your

alessandro.dona — Tue, 17 Mar 2015 21:01:21 GMT

Hi Josè,

have you solved your issue?

Now it is also mine:-)

It looks line a 8.0.115 or prime 2.2 bug.

Hello,It worked for me with

SHABEEB KUNHIPOCKER — Fri, 27 Mar 2015 08:33:28 GMT

Hello,

It worked for me with prime version 2.2 and controller version 7.6.130. If there is any dynamic interface in the controller with ip address from the same subnet as prime , then remove it and resync. It should work.

Thanks

Shabeeb

Hi,please check this posthttp

abwahid — Mon, 04 May 2015 10:00:50 GMT

Hi,

please check this post

http://itsnotthefirewall.com/2014/08/07/cisco-wlc-not-adding-to-prime-infrastructure/

I Solved it , I changed

joseavalero — Wed, 06 May 2015 11:18:46 GMT

I Solved it , I changed "Maximum VarBinds per Get PDU" from 30 to 15 in Administration > Settings > System Settings > SNMP Settings