topic Re: 1300 Bridge association in Wireless https://community.cisco.com/t5/wireless/1300-bridge-association/m-p/452029#M192244 <HTML><HEAD></HEAD><BODY><P>The install mode is required initially till the antennas are aligned. After that you can change the modes to root and non-root bridge. Try doing this change. it will work as expected.</P></BODY></HTML> Thu, 24 Nov 2005 16:22:33 GMT m.singer 2005-11-24T16:22:33Z 1300 Bridge association https://community.cisco.com/t5/wireless/1300-bridge-association/m-p/452028#M192243 <P>I have a pair of 1310 Bridges set up in a point-to-point environment. The problem I picked up is when my root goes down after a power failure, the non-root does not associate again until I power it down and up again.</P><P></P><P>Is there a setting to tell the non-root to keep trying till the association is back again?</P><P></P><P>The settings on both bridges are:</P><P></P><P> station-role install root</P><P></P><P> station-role install non-root</P><P></P><P></P> Sun, 04 Jul 2021 18:20:58 GMT https://community.cisco.com/t5/wireless/1300-bridge-association/m-p/452028#M192243 deanyoung 2021-07-04T18:20:58Z Re: 1300 Bridge association https://community.cisco.com/t5/wireless/1300-bridge-association/m-p/452029#M192244 <HTML><HEAD></HEAD><BODY><P>The install mode is required initially till the antennas are aligned. After that you can change the modes to root and non-root bridge. Try doing this change. it will work as expected.</P></BODY></HTML> Thu, 24 Nov 2005 16:22:33 GMT https://community.cisco.com/t5/wireless/1300-bridge-association/m-p/452029#M192244 m.singer 2005-11-24T16:22:33Z