AP1200 bootstrap problem

raymond.l — Sun, 04 Jul 2021 18:16:12 GMT

I got an AP1200 which can only load the sytem bootstrap. Details as follow:

c -- Copy file

f -- File dir

l -- downLoad file into DRAM

u -- Upload file

p -- xfer Protocol

n -- coNsole

r -- Run

s -- System info.

System ID: (Not shown in the forum)

Motherboard: IBM405 200MHz, 8192KB FLASH, 16384KB DRAM, Revision 04

Bootstrap Ver. 1.00: FLASH, CRC 1C914641 (OK)

Initialization: OK

Memory Bank total used left

DRAM 16742624 0 16742624

Config 524288 0 524288

FLASH 7602176 0 7602176

Memory Bank:File address size encoding type flags

So there's nothing inside, then I tried to follow the guidelines from http://www.cisco.com/en/US/products/hw/wireless/ps441/products_tech_note09186a0080093c37.shtml to load image files into DRAM. When the transfer completed in Hyper-terminal, it still showed

Memory Bank total used left

DRAM 16742624 0 16742624

Config 524288 0 524288

FLASH 7602176 0 7602176

My task is to upgrade this AP device to Cisco ISO. Any ideas what I can do? Thanks!!!

Re: AP1200 bootstrap problem

raymond.l — Fri, 28 Oct 2005 04:52:48 GMT

Sorry everyone, I solved the problem by using AP1200-Cisco-IOS-Upgrade-Image-v3.img downloaded from Cisco and it works fine now.