topic Configuration changes via browser not written to startup in Wireless

Configuration changes via browser not written to startup

mheidemann — Sun, 04 Jul 2021 17:33:50 GMT

I have recently discoverd that some changes applied via a browser interface are not applied to the startup configuration. I confirm this by starting a telnet session to the device and entering show start. This appears to be inconsistant in that sometimes I see the change from sh start and other times I do not.

Im using IOS release

c1200-k9w7-tar.123-2.JA

Re: Configuration changes via browser not written to startup

mheidemann — Tue, 15 Mar 2005 15:53:15 GMT

Update -

Discoverd that when I telnet to a device and try to copy running configuration to startup configuration, I recive the following error message.

apmp12001e#copy run start

Destination filename [startup-config]?

Building configuration...

Error writing new config file "flash:/config.txt.new"

nv_done: unable to open "flash:/config.txt.new"

Error writing new block-fs file "flash:/private-multiple-fs.new"[OK]

Re: Configuration changes via browser not written to startup

DWAM_2 — Mon, 08 Aug 2005 07:48:51 GMT

Hello !

I have got exactly the same problem with same IOS :

ap#wr

Building configuration...

nv_done: unable to open "flash:/config.txt.new"

nv_done: unable to open "flash:/private-multiple-fs.new"[OK]

NVRAM Verification Failed

ap#

Is it a defective nvram ap ?

Best regards.

Re: Configuration changes via browser not written to startup

daylight28 — Tue, 14 Mar 2006 13:38:52 GMT

hi, did u managed to solve this IOS problem on your AP ?

i am also facing the same problem with one of my AP.

Re: Configuration changes via browser not written to startup

jmagnusson — Wed, 15 Mar 2006 14:57:38 GMT

upgrade to at least 123-7.ja2