topic Re: Max. Distance & Throughput using bridge+solid dish (ETSI vs. in Wireless

Max. Distance & Throughput using bridge+solid dish (ETSI vs. US Standard)

a.kiprawih — Mon, 05 Jul 2021 06:28:44 GMT

Using ETSI standard, it it possible to connect 2 sites (distance=10KM) using bridge+solid dish antenna with throughput between 5Mbps to 11Mbps?

I was told that the information in Cisco website was tested based on US standard, and if the solution is based on ETSI standard, this might not working.

Thanks.

Re: Max. Distance & Throughput using bridge+solid dish (ETSI vs.

dave.reid — Thu, 24 Oct 2002 12:07:49 GMT

Use the bridge range calculator

http://www.cisco.com/en/US/products/hw/wireless/ps458/prod_technical_reference_list.html

Re: Max. Distance & Throughput using bridge+solid dish (ETSI vs.

a.kiprawih — Fri, 25 Oct 2002 01:09:15 GMT

Thank you for the info.

However, since ETSI standard is applicable for certain countries, including Malaysia, the Aironet International Power Compliance Chart shows that Malaysia falls under the same group with US.

So, if I were to use use the xls calculation formula (distance + quality/throughput) , should I use ETSI or US standard? Theoritically it might be working.

Thanks.

Re: Max. Distance & Throughput using bridge+solid dish (ETSI vs.

dave.reid — Mon, 28 Oct 2002 13:04:34 GMT

If you are going to comply with the ETSI limits, select that choice. The succeed/fail math is the same; all that changes are the regulations.