topic Re: Wireless E&M in Wireless https://community.cisco.com/t5/wireless/wireless-e-m/m-p/14765#M196006 <HTML><HEAD></HEAD><BODY><P>The use of WLAN 802.11b bridges can provide network connectivity up to a data rate of 33Mbps. This will require 3 antenna and bridges per side. The bridge can tie into a switch to provide an Ethernet connection to your PBX&#146;s (as long as there is Ethernet support on your PBX). </P></BODY></HTML> Wed, 01 Aug 2001 14:06:42 GMT bstremp 2001-08-01T14:06:42Z Wireless E&M https://community.cisco.com/t5/wireless/wireless-e-m/m-p/14764#M196005 <P>I have two PBXs in two buildings about 100 yards from each other with a good line of sight. How can I link the two phone systems using a radio solution. Ther are only 16 users at the smaller of the two buildings.</P><P></P><P>What is the best technology?</P> Mon, 05 Jul 2021 19:00:07 GMT https://community.cisco.com/t5/wireless/wireless-e-m/m-p/14764#M196005 chris.cox 2021-07-05T19:00:07Z Re: Wireless E&M https://community.cisco.com/t5/wireless/wireless-e-m/m-p/14765#M196006 <HTML><HEAD></HEAD><BODY><P>The use of WLAN 802.11b bridges can provide network connectivity up to a data rate of 33Mbps. This will require 3 antenna and bridges per side. The bridge can tie into a switch to provide an Ethernet connection to your PBX&#146;s (as long as there is Ethernet support on your PBX). </P></BODY></HTML> Wed, 01 Aug 2001 14:06:42 GMT https://community.cisco.com/t5/wireless/wireless-e-m/m-p/14765#M196006 bstremp 2001-08-01T14:06:42Z Re: Wireless E&M https://community.cisco.com/t5/wireless/wireless-e-m/m-p/14766#M196007 <HTML><HEAD></HEAD><BODY><P>Why not install telco T-1 radios? They present native T-1 interfaces that will likely connect directly to your PBXs, with no VoIP, gateways, etc.</P><P></P><P>Very straightforward, clean solution.</P></BODY></HTML> Fri, 31 Aug 2001 01:46:21 GMT https://community.cisco.com/t5/wireless/wireless-e-m/m-p/14766#M196007 ED CARMODY 2001-08-31T01:46:21Z