topic Re: 3802 Aps not showing up in Controller 3850 GUI after being configured in Wireless

3802 Aps not showing up in Controller 3850 GUI after being configured

aminebenmessaoud — Mon, 05 Jul 2021 19:11:14 GMT

I tried configuring the controller so the APs auto-join in with CAPWAP but when I open the controller GUI no APs show up and I get these error messages in the AP :

config down up [*06/15/2020 22:26:13.4856] [06/15/2020 22:26:15.6000] wired0 emac 0: link up [06/15/2020 22:26:15.6500] wired0: link up [06/15/2020 22:26:15.7000] wired0: started [*06/15/2020 22:26:15.7505] aptrace_register_sysproc_fn: duplicate registeratio n for 'wired'

Re: 3802 Aps not showing up in Controller 3850 GUI after being configured

rafafilho11 — Wed, 17 Jun 2020 15:00:36 GMT

Can you confirm if the access-point is on the capwap mode ?

In case the access-point is in the mobility express mode you'll need to convert them:

Converting an AP from Mobility Express to CAPWAP Type
To convert a Mobility Express AP into a CAPWAP AP, ap-type capwap from mobility express to lwap
Connect to the Console Port, Telnet or SSH to the AP.
Login to the Mobility Express controller console.

Type: apciscoshell (connect to the AP console)
Login to the AP console using the username Cisco and password Cisco. Both are case-sensitive.
Enter enable.
Type command: ap-type capwap, and confirm .

(Cisco Controller) > apciscoshell

APxxxxxx> enable

APxxxxxx capwap ap primary-base mywlc_name x.x.x.x

Re: 3802 Aps not showing up in Controller 3850 GUI after being configured

aminebenmessaoud — Wed, 17 Jun 2020 19:38:46 GMT

yes the access point is on capwap mose

Re: 3802 Aps not showing up in Controller 3850 GUI after being configured

Leo Laohoo — Wed, 17 Jun 2020 23:18:46 GMT

Time and date is wrong.

Re: 3802 Aps not showing up in Controller 3850 GUI after being configured

aminebenmessaoud — Fri, 19 Jun 2020 08:20:53 GMT

I changed the date but it still didn't fix my problem

Re: 3802 Aps not showing up in Controller 3850 GUI after being configured

Mark Elsen — Fri, 19 Jun 2020 09:08:25 GMT

- What software version is the 3850 running ?

Re: 3802 Aps not showing up in Controller 3850 GUI after being configured

aminebenmessaoud — Fri, 19 Jun 2020 09:13:26 GMT

16.3.9