topic Issue with setup Single Point Setup, 2 devices Cluster-Controller in Wireless

Issue with setup Single Point Setup, 2 devices Cluster-Controller

zuyd32724 — Mon, 05 Jul 2021 19:10:22 GMT

Hi,

I have 2 Cisco WAP371 devices.

1. WAP371-E-K9 V03

2. WAP371-E-K9 V02

Doesnt matter if I setup the first or the second one first and join the other. When I join the 2nd device its not displayed as a device in the master. When checking the SPS both devices are marked Yes with Cluster-Controller

Firmware has been upgrade on both to 1.3.0.7

1st

Single Point Setup allows WAP371-A-K9 access points to propagate settings.

Single Point Setup: Enabled

Access Points detected in Cluster: WLAN_Cluster2

Location	MAC Address	IP Address	Cluster-Priority	Cluster-Controller
home	00:22:44:66:88:00	192.168.178.150	0	yes

To change your clustering options, click "Disable Single Point Setup".

Enter the location of this AP.
Location:	(Range: 1-64 Characters)

Enter the name of the cluster for this AP to join.
Cluster Name:	(Range: 1-64 Characters)
Clustering IP Version:	IPv6 IPv4
Cluster-Priority:	(Range: 0-255, Default: 0)

2nd

Single Point Setup allows WAP371-E-K9 access points to propagate settings.

Single Point Setup: Enabled

Access Points detected in Cluster: WLAN_Cluster2

Location	MAC Address	IP Address	Cluster-Priority	Cluster-Controller
home	A0:55:4F:67:51:F0	192.168.178.24	0	yes

To change your clustering options, click "Disable Single Point Setup".

Enter the location of this AP.
Location:	(Range: 1-64 Characters)

Enter the name of the cluster for this AP to join.
Cluster Name:	(Range: 1-64 Characters)
Clustering IP Version:	IPv6 IPv4
Cluster-Priority:	(Range: 0-255, Default: 0)

When joining its mentioned successful added.

Can somebody please help me.

Re: Issue with setup Single Point Setup, 2 devices Cluster-Controller

pieterh — Mon, 15 Jun 2020 15:43:26 GMT

my guess is the AP's each joined it's own cluster (with just a single AP)

The cluster name is not sent to other WAPs so you must configure the same name on each device that is a member.

check the cluster-name match exactly! (try a name with all lowercase)
you can check the web-interface to show how many AP's are connected in a cluster

Re: Issue with setup Single Point Setup, 2 devices Cluster-Controller

zuyd32724 — Tue, 16 Jun 2020 15:43:55 GMT

thanks for the reply.

They are both mentioned with only 1 AP.

I changed the Cluster name to, still joining isnt done. This is the reponse message i receive after joining

Device Setup Complete

Congratulations, your access point has been set up successfully. We strongly recommend that you save these settings by writing them down or by copying and pasting them into a text document. You will need these settings later when you add other wireless computers or devices to your network.


	Cluster Name:	a

	Network Name (SSID):	ciscosb (5 GHz Radio)

	Network Security Type:	plain-text

	Security Key:

but its still not joined to the cluster. Is there a port or something that needs to be open? an ip where the cluster-controller is located?

thanks