topic Re: WLC 9800 CSSM on-prem in Wireless

WLC 9800 CSSM on-prem

as00001111 — Mon, 05 Jul 2021 19:07:36 GMT

Hi,

I got a CSSM on-prem Server and there are a lot of AIR-DNA licenses.

Can you tell me how to link the C9800 to the CSSM on-prem?

I can't find any useful information in the internet.

Thank you in advance!

Re: WLC 9800 CSSM on-prem

mohammedshahidali88 — Tue, 02 Jun 2020 10:34:02 GMT

Hi,
You have to generate a Token from CSSM server and add it to WLC. And also make sure that from in your smart account which is created on Cisco Portal these licenses are added. And generate license request file from Cisco Portal and upload it to CSSM.

Refer below link

https://www.youtube.com/watch?v=sbQz52miAlA

https://www.cisco.com/c/en/us/td/docs/wireless/controller/9800/config-guide/b_wl_16_10_cg/smart-licensing.html

Mark my post if it resolves your issue.

Re: WLC 9800 CSSM on-prem

as00001111 — Wed, 03 Jun 2020 11:51:41 GMT

But how to put the ip address of the CSSM and so forth.

The link you sent me only describes how to apply the token.

But token doesn't contain ip addresses.

Re: WLC 9800 CSSM on-prem

as00001111 — Fri, 05 Jun 2020 15:56:47 GMT

Hi,

any hints on how configuring the ip of the cssm?

Re: WLC 9800 CSSM on-prem

Rich R — Mon, 08 Jun 2020 01:51:10 GMT

The 9800 documentation seems to be missing the detail on this but it's basically the standard smart-call-home configuration.
See the "Configuring the Call Home Service for Cisco Smart Software Manager On-Prem" section in https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-9/configuration_guide/sys_mgmt/b_169_sys_mgmt_9300_cg/configuring_smart_licensing.html
The CSSM server should have provided the URL to use.

Re: WLC 9800 CSSM on-prem

Nicolas Darchis — Mon, 08 Jun 2020 08:18:20 GMT

On-prem CSSM is currently not supported with 9800 and will likely throw errors. This issue is supposed to be fixed by end of summer timeframe on the CSSM side.

Re: WLC 9800 CSSM on-prem

eliegerges — Mon, 15 Jan 2024 11:31:12 GMT

Hello,

Please i need a clear documentation on how to connect a 9800 WLC to a Smart Software Manager on Prem, both CLI and GUI methods.

Thank you