topic Re: WLC's command to show PoE status of all connected access points in Wireless

WLC's command to show PoE status of all connected access points

Andrey128 — Mon, 05 Jul 2021 19:05:31 GMT

Access point should negotiate required power with PoE switch via CDP / LLDP and switch should be able to provide requested power per its design (we exclude the case of old standard PoE switch and new standard access point).

On a WEB interface of WLC its possible to see PoE status of each access point, e.g. "PoE/Full Power" or "PoE/Medium Power (15.4 W)". I haven't found a command line which gives such information, can you please inform.

Re: WLC's command to show PoE status of all connected access points

Leo Laohoo — Tue, 26 May 2020 06:35:30 GMT

Never came across one.

If you have a list of the APs, then you could plug the the following into an Excel formula:

grep include AP.Name|Power.Type/Mode "show ap config general <NAME>"

Re: WLC's command to show PoE status of all connected access points

Rasika Nayanajith — Tue, 26 May 2020 06:41:18 GMT

Since these are individual AP specific detail, you have to run it against each AP

(WLC3) >grep include "Power Type" "show ap config general <AP_NAME>"
Press any key to continue..
Power Type/Mode.................................. PoE/Full Power

There are 1 lines matching the pattern Power Type

HTH

Rasika

*** Pls rate all useful responses ***