topic Re: WLC CLI Commands in Wireless

WLC CLI Commands

terrywatson651 — Mon, 05 Jul 2021 17:02:22 GMT

Hi all

Haing recently upgraded an HA pair of 8510 to version 8.3.143.0 I suddenly found that the switches were complaining about Duplex mismatches on ports connected to APs. I did some troubleshooting and googling and came to the conclusion that these were erroneous messages. However I do have a couple of questions regarding some of the CLI commands I used:

1. show ap config general

This displayed that the Duplex was Full, is this a report that the Duplex is configured as Full, or is it reporting that the state of the port is Full?

2. config ap ethernet duplex autho speed auto <Cisco AP>

This command is deprecated, is there another command that allows me to set the duplex and speed of the AP port(s)?

Kind Regards

Terry

Re: WLC CLI Commands

Leo Laohoo — Tue, 12 Mar 2019 10:23:24 GMT

@terrywatson651 wrote:

I suddenly found that the switches were complaining about Duplex mismatches on ports connected to APs.

Don't bother troubleshooting. It's a known bug: FN - 70252 - Inaccurate "CDP-4-DUPLEX_MISMATCH" Messages Are Logged on AP Switchports - Software Upgrade Recommended

Re: WLC CLI Commands

terrywatson651 — Thu, 14 Mar 2019 11:20:38 GMT

Thanks for the response, however I know it's a known bug. My questions are related to what the CLI commands are telling me rather than the issue itself.

Regards

Terry

Re: WLC CLI Commands

olajideayodele1 — Fri, 15 Mar 2019 12:30:19 GMT

Please, I need help on setting up WLC5508. Have made initial configuration and can WLC via service port but cannot access via management port. Also, I cannot ping the management interface from my switch. Both management interface and service port are in different IP network.