topic Scott, in Wireless

1131AG password reset

isaaco001 — Mon, 05 Jul 2021 13:28:33 GMT

Dear Community,

I have consoled into an 1131AG LWAPP but i can get past the user exec mode > . I have checked the doc on the default password "Cisco" which is case sensitive and commands are not available in this mode to erase private-config file.I have reset the controller to factory but still i am prompted with the password which by default should be cisco.Please assist.

Thank you all.

Regards,

Isaac.

Lightweight AP's don't have

Scott Fella — Tue, 31 Jan 2017 14:09:50 GMT

Lightweight AP's don't have enable mode. Configuration is done on the controller. If you want an autonomous AP, you will have to convert that to autonomous.

-Scott

*** Please rate helpful posts ***

Scott,

isaaco001 — Tue, 31 Jan 2017 14:25:11 GMT

Scott,

This is exactly what i am trying to achieve(converting to autonomous mode) but the commands to convert the lwapp aren't in the default mode,there is higher mode(privilege/global) i think.I will keep troubleshooting.Thanks for insights.

Regards,

Isaac.

You use the mode button on

Scott Fella — Tue, 31 Jan 2017 15:05:31 GMT

You use the mode button on the read of the AP by the console/Ethernet port.

Search for lightweight to autonomous mode button.

You will find a bunch of information on this. There is no enable.

-Scott

*** Please rate helpful posts ***

Scott,

isaaco001 — Wed, 01 Feb 2017 11:24:21 GMT

Scott,

Meanwhile i have been trying to work with 1572(changing to autonomous mode) but whenever the files are extracting the bvi interface changes to dhcp and the message "premature end of tar file" is seen.I configure the bvi interface to static but changes to dhcp every time.I am using generic tftpserver32.I have verified the file in a router(md5) and its fine.Please assist.Thanks.

Regards,

Isaac.

Scott,

isaaco001 — Wed, 01 Feb 2017 12:33:13 GMT

Scott,

Figured it out it was the default-gateway ip that had to be set(1572).Thanks.

Regards

Most AP's you would use the

Scott Fella — Wed, 01 Feb 2017 15:41:57 GMT

Most AP's you would use the mode button to upload the image to the AP via tftp. This is the easiest way to upload any image to an AP.

-Scott

*** Please rate helpful posts ***