topic My pleasure :) in Wireless

How to enter to Global configuration mode?

hannu.lehmussaari — Mon, 05 Jul 2021 08:39:38 GMT

Hi,
I have new Cisco AIR-CAP2602i-E-K9 and I try to configure it via CLI.

I log in, give username and password (defaults) and I'm in User EXEC mode.

Then I type enable and give password to get Privileged EXEC. At least command prompt changed to # and more commads are available.

Then I try to give 'configure' command to get next, Global configuration mode.

Problem: there is no 'configure' named command.

What to do? How to get further?

Best regards,
Hannu

n4niteshkumar — Mon, 06 Oct 2014 13:13:10 GMT

Put ? symbol in # prompt and it will show u possible commands,here u can look for configuration related command.

hannu.lehmussaari — Mon, 06 Oct 2014 13:27:26 GMT

Problem is, that when I go to Privileged EXEC mode, there is NOT 'configure' command.

mohanak — Mon, 06 Oct 2014 14:32:36 GMT

Convert the AP to Autonomous and TRY:

hannu.lehmussaari — Mon, 06 Oct 2014 17:44:11 GMT

Sounds and looks difficult. Is this the ONLY way?

Daniel Ordóñez Flores — Mon, 06 Oct 2014 18:17:55 GMT

Hi.

If you need to configure something on this AP in CAPWAP mode by CLI, you should write:

"debug capwap console cli" In other case as Mohanak told you you need to convert your AP to Autnomous mode.

**Please rate useful answers**

hannu.lehmussaari — Tue, 07 Oct 2014 06:23:40 GMT

That works!

Thanks!

Hannu

Daniel Ordóñez Flores — Tue, 07 Oct 2014 15:33:27 GMT

My pleasure 🙂