topic Re: SAP2602 Initial configuration in Wireless

SAP2602 Initial configuration

meberhard — Sun, 04 Jul 2021 07:56:12 GMT

This is my first 2602 AP. Do all the nifty functions of 802.11n start automatically or do I have to enable them? Specifically I am asking about channel bonding and ClientLink.

I did find where I can increase the channel width on my 5GHz band but wasn't sure if that was all that I had to do.

Re: SAP2602 Initial configuration

Scott Fella — Wed, 25 Sep 2013 13:53:23 GMT

For 802.11n you need to use open authentication or WPA2/AES. Also your channel width in the 5ghz has to be set to 40mhz to achieve up to 300mbps. With default of 20mhz channel width you can have up to 144mbps. WMM has to be enabled also. Here is a doc to help you.

http://www.cisco.com/en/US/docs/wireless/access_point/12.4.25d.JA/Configuration/guide/scg12.4.25d.JA-chap6-radio.html

Sent from Cisco Technical Support iPhone App

Re: SAP2602 Initial configuration

meberhard — Wed, 25 Sep 2013 15:16:17 GMT

Thank you for the help; I actually had already set the security to WPA2/AES (although I hadn't mentioned that earlier.)

Do I have to do anything with the MCS rates? I notice that they are all disabled.

SAP2602 Initial configuration

Scott Fella — Wed, 25 Sep 2013 15:53:38 GMT

by default it shouldn't be disabled, but yeah, you need to enable them. Might be better to clear the config and start from scratch.

Thanks,

Scott

Help out other by using the rating system and marking answered questions as "Answered"