topic Autonomous CAP3602 in Wireless

Autonomous CAP3602

Gateway Church — Sun, 04 Jul 2021 07:54:01 GMT

I have a 3602e AP that I have loaded the 15.2 Autonomous IOS onto. I am just not familiar with configuring the AP from this gui. Does anyone have a guide for configuring my wireless network. Primarily I have the interfaces configured for my Vlans and my trunk to the AP is working, but I cannot get the SSIDs I have setup to broadcast. It is almost like I just haven't turned them on, but I can't find where to do so.

Re: Autonomous CAP3602

Gateway Church — Fri, 20 Sep 2013 18:00:56 GMT

Here is the current config if it would help.

https://www.dropbox.com/s/4hew4jjhk9edyxv/config.txt

Re: Autonomous CAP3602

Rasika Nayanajith — Fri, 20 Sep 2013 19:35:04 GMT

I cannot see a default-gateway configured for this AP. Please check that & try

HTH

Rasika

Autonomous CAP3602

Gateway Church — Fri, 20 Sep 2013 19:52:30 GMT

I don't want to have a system default gateway otherwise all traffic would tunnel through that single vlan. I would rather it be segmented. Less holes in my ACLs. I did enable IP Routing. The delima I have is just getting the SSID to broadcast.

Autonomous CAP3602

Rasika Nayanajith — Fri, 20 Sep 2013 19:56:41 GMT

try "mbssid guset-mode" under your SSID configuration in CLI

Re: Autonomous CAP3602

Stephen Rodriguez — Fri, 20 Sep 2013 20:02:53 GMT

MBSSID guest-mode isn't going to help.

You need to remove the mobility network ID

dot11 ssid TEST
   vlan 40
   max-associations 50
   authentication open 
   no ids mfp client


That command is/was for when you had a WLSM

And having a default gateway is for the AP to use so it knows where to 
send it's traffic that is destined for something off net.  So if your 
managment is from a different subnet than the AP you would need to have 
it configured.

The client traffic is going to be bridged down to the VLAN that you 
link to the SSID.

HTH,
Steve

------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered

Autonomous CAP3602

Gateway Church — Fri, 20 Sep 2013 20:13:56 GMT

Good catch regarding mobility network ID, but it is still not broadcasting the SSID: TEST.

Autonomous CAP3602

Stephen Rodriguez — Fri, 20 Sep 2013 20:16:22 GMT

oh, guest-mode under the SSID.

HTH,
Steve

------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered

Re: Autonomous CAP3602

Leo Laohoo — Fri, 20 Sep 2013 23:09:06 GMT

I have a 3602e AP that I have loaded the 15.2 Autonomous IOS onto.

Stupid question: What external antennas are you using for the 3602e?

Re: Autonomous CAP3602

Gateway Church — Fri, 20 Sep 2013 23:12:14 GMT

AIR-ANT2524DW-R

Why?

Re: Autonomous CAP3602

Leo Laohoo — Sat, 21 Sep 2013 23:27:32 GMT

Just want to make sure you installed a dual-band antenna. I've seen a few posts with the same issue and it was because they throught that the AP has both internal and external antenna and the other post was he stuck an 802.11a antenna.