Need some help

pslph2012 — Sun, 04 Jul 2021 05:56:14 GMT

Hi, I am attempting to configure a Aironet 1042N AP From my understanding it does not have an IP out the box. I attempted to access the console which I can view it booting up but then it hangs on the following:

*Mar 1 00:14:23.027: %SYS-5-RESTART: System restarted --

Cisco IOS Software, C1040 Software (C1140-K9W7-M), Version 12.4(25d)JA1, RELEASE SOFTWARE (fc1)

Technical Support: http://www.cisco.com/techsupport

Compiled Thu 11-Aug-11 02:58 by prod_rel_team

*Mar 1 00:14:23.028: %SNMP-5-COLDSTART: SNMP agent on host ap is undergoing a cold start

*Mar 1 00:14:23.987: %LINEPROTO-5-UPDOWN: Line protocol on Interface BVI1, changed state to up

*Mar 1 00:14:24.002: %LINEPROTO-5-UPDOWN: Line protocol on Interface Dot11Radio1, changed state to down

*Mar 1 00:14:24.002: %LINEPROTO-5-UPDOWN: Line protocol on Interface Dot11Radio0, changed state to down

*Mar 1 00:15:45.717: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet0, changed state to down

*Mar 1 00:15:47.717: %LINK-3-UPDOWN: Interface BVI1, changed state to down

*Mar 1 00:15:48.717: %LINEPROTO-5-UPDOWN: Line protocol on Interface BVI1, changed state to down

*Mar 1 00:15:55.717: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet0, changed state to up

*Mar 1 00:16:04.898: %LINK-3-UPDOWN: Interface BVI1, changed state to up

*Mar 1 00:16:05.898: %LINEPROTO-5-UPDOWN: Line protocol on Interface BVI1, changed state to up

It does nothing after that just hangs I am unable to obtain a command prompt

Can anyone give me some insight as why this might be.

Thanks ahead of time

Re: Need some help

Stephen Rodriguez — Sat, 27 Oct 2012 01:43:10 GMT

With the AP you have I make sure that you have flow control set to none. After that you should be able to access the console

Steve

Sent from Cisco Technical Support iPhone App

topic Re: Need some help in Wireless

Need some help

Re: Need some help