https://community.cisco.com/t5/wireless/bandwidth-management-using-5508/m-p/2015725#M211702 <P>I setup a WLC5508 with 2 SSIDs, one for guest traffic and another for internal users.&nbsp; They are in separate subnets and are routed out to the internet via 2 different isps, with the guest network going over a bonded t1 and the internal users going out the primary internet connection for the company.&nbsp; While this works as desired and we've verified that while on the guest network we're going out the right isp, we've encountered an issue with saturation of the bonded t1 pipe by guests.&nbsp; We'd like to find a way to limit a guest to a capped down/up stream if possible, with downstream being the most important.&nbsp; The infrastructure includes 3560 switches and AIR-CAP3502I-A-K9 access points.&nbsp; </P> Sun, 04 Jul 2021 05:32:57 GMT mumbles202 2021-07-04T05:32:57Z https://community.cisco.com/t5/wireless/bandwidth-management-using-5508/m-p/2015725#M211702 <P>I setup a WLC5508 with 2 SSIDs, one for guest traffic and another for internal users.&nbsp; They are in separate subnets and are routed out to the internet via 2 different isps, with the guest network going over a bonded t1 and the internal users going out the primary internet connection for the company.&nbsp; While this works as desired and we've verified that while on the guest network we're going out the right isp, we've encountered an issue with saturation of the bonded t1 pipe by guests.&nbsp; We'd like to find a way to limit a guest to a capped down/up stream if possible, with downstream being the most important.&nbsp; The infrastructure includes 3560 switches and AIR-CAP3502I-A-K9 access points.&nbsp; </P> Sun, 04 Jul 2021 05:32:57 GMT https://community.cisco.com/t5/wireless/bandwidth-management-using-5508/m-p/2015725#M211702 mumbles202 2021-07-04T05:32:57Z https://community.cisco.com/t5/wireless/bandwidth-management-using-5508/m-p/2015726#M211703 <HTML><HEAD></HEAD><BODY><P>You can do bandwidth limiting on the WLC but currently it is only downstream from the WLC. </P><P></P><P>What you'll want to do is enable rate limiting from the edge in on the guest subnet. This will give you the greatest control of your bandwidth on the network</P><P></P><P>Steve</P><P></P><P>Sent from Cisco Technical Support iPhone App</P></BODY></HTML> Fri, 17 Aug 2012 20:01:07 GMT https://community.cisco.com/t5/wireless/bandwidth-management-using-5508/m-p/2015726#M211703 Stephen Rodriguez 2012-08-17T20:01:07Z