topic Re: default pwd in Wireless

default pwd

dave dave — Sun, 04 Jul 2021 03:09:35 GMT

hi! I did a conversion from autonomous AP to lightweight AP (1240) using the cisco upgrade tool. After the conversion, i tried to console into the AP but the default password of Cisco and username Cisco doesn;t work. Any idea what's the default password after the conversion? I know that i can change that from the controller, but is that the only way to do it? Thanks.

Re: default pwd

Stephen Rodriguez — Thu, 05 May 2011 16:15:49 GMT

default is Cisco/Cisco, you may want to try the user/pass that you had when it was autonomous.

Cheers,
Steve

If this helps you and/or answers your question please mark the question as "answered" and/or rate it, so other users can easily find it.

Re: default pwd

Surendra BG — Thu, 05 May 2011 16:36:01 GMT

Hi,

If the AP is already registered to the WLC, then the only way is to configure the same sing the WLC GUI... If its not yet registered, then password recovery using Mode button does not work on the LWAPP APs...

Lemme know if this answered ur question!!

Regards

Surendra

Re: default pwd

Vinay Sharma — Fri, 03 Jun 2011 15:18:16 GMT

Dave,

Please mark this Question as "Answered" if you got the correct information from Stephen and surendra.

thanks,

Vinay

Re: default pwd

JeanWarner18317 — Fri, 20 Sep 2019 18:07:06 GMT

I've tried Cisco/Cisco and it doesn't work. I've also tried admin/cisco and that doesn't work. Any ideas?

Re: default pwd

patoberli — Mon, 23 Sep 2019 15:14:46 GMT

Which AP model?
You can try to reset it to factory defaults with the Mode button and a console cable.