1300 installation

bvelez — Sat, 03 Jul 2021 21:19:01 GMT

What are the specs for coax cable used in the installation of a 1300? Interested in type,square inches of the cable etc.

Re: 1300 installation

Rob Huffman — Mon, 09 Jul 2007 17:54:36 GMT

Hi Bob,

Dual RG-6 coaxial cable to run from the power injector to the 1300. See attached notes:

Cisco Aironet 1300 Series Access Point/Bridge Power Injector

The Cisco Aironet 1300 Series Outdoor Access Point/Bridge Power Injector,converts the standard 10/100 BaseT Ethernet interface that is suitable for weather protected areas to a dual F-Type connector interface for coax cables that are more suitable for harsh outdoor environments. The Power Injector also provides power to the outdoor unit over the same cables with a power discover feature and surge protection. To support longer cable runs from your wireless network switch or router, the Power Injector LR is designed to accommodate up to a 100 meter coaxial cable run plus 100 meters of indoor cat5 cable enabling total cable runs up to 200 meters. The Cisco Aironet 1300 Series Outdoor Access Point/Bridge ships with the Power Injector LR2 and an AC power supply.

From this link:

http://www.cisco.com/en/US/products/ps5861/products_data_sheet09186a008022551d.html

Cisco Aironet 1300 Series Outdoor Access Point/Bridge Hardware Installation Guide

Ethernet Ports

The access point/bridge dual-coax Ethernet ports consists of a pair of 75-ohm F-type connectors, linking the unit to your 100BASE-T Ethernet LAN through the power injector. The dual-coax cables are used to send and receive Ethernet data and to supply inline 48-VDC power from the power injector to the access point/bridge.

Power

The access point/bridge receives inline power from the Cisco Aironet Power Injector (hereafter called the power injector). Dual-coax cables are used to provide Ethernet data and power from the power injector to the access point/bridge. The power injector is an external unit designed for operation in a sheltered environment, such as inside a building or vehicle. The power injector also functions as an Ethernet repeater by connecting to a Category 5 LAN backbone and using the dual-coax cable interface to the access point/bridge.

From this link:

http://www.cisco.com/en/US/products/ps5861/products_installation_guide_book09186a00804d3095.html

AIR-PWRINJ-BLR2

F-Type Connectors

Dual coaxial cable carries full-duplex Ethernet, DC power, and full-duplex console port (RS-232 connection)

From this link:

http://www.cisco.com/en/US/products/ps5861/products_data_sheet09186a00802252e1.html

Here are the specs:

dual F-Type connector interface

Dual RG-6 Coax 0.041 inch (1.05 mm) center conductor diameter

From this doc;

http://www.cisco.com/en/US/products/hw/cable/ps801/products_installation_guide_chapter09186a008007e013.html#xtocid149761

Hope this helps!

Rob

Re: 1300 installation

sethgarnar — Mon, 09 Jul 2007 17:54:43 GMT

You need RG6 coax cable for 1300's. We use Belden 1694A type cable for our installs.

topic 1300 installation in Wireless

1300 installation

Re: 1300 installation

Re: 1300 installation