topic Re: AP1200 in Wireless

AP1200

ali.asghar — Sun, 04 Jul 2021 16:06:14 GMT

Is it possible to create a Management Interface VLAN in AP1200, and assign an IP address. I like to create four VLANs in AP1200, just like a Catalyst Layer 2 switch, and create a VLAN Virtual Interface w/ an IP address for remote managment, the other (3) vlans will act as a seperate broadcast domains.

2) Since it will have multiple VLANS, I will have to trunk ports. Will I only have to trunk 802.1q Ethernet port that connects to the wired LAN?

Re: AP1200

5r-graves — Thu, 23 Oct 2003 23:01:43 GMT

You can create a management interface on the 1200. VLAN 1 should already be created on the AP.

As far as the VLANS and trunks go, all you have to do is trunk the Ethernet link between the 1200 and the switch.

If you have 3 VLANS, you will have to set up 3 SSID's and associate the SSID's to the VLANS on a one for one bases. When you configure your clients, you will configure them with the SSID of the VLAN that you want them in.

For example if you have a SSID of Test mapped to VLAN 10, then all clients that you want in VLAN 10 will have to use the Test SSID.

Re: AP1200

5r-graves — Fri, 24 Oct 2003 10:23:22 GMT

You can use the below document for reference if you need.

http://www.cisco.com/en/US/products/hw/wireless/ps430/products_configuration_guide_chapter09186a00800e02cb.html