topic Re: Double Broadcast SSID in Wireless

Double Broadcast SSID

Reedho — Mon, 05 Jul 2021 18:02:53 GMT

I just configured AP 1830 via firmware mobility express via the GUI and it worked. But after restarting the system, the device still broadcasts the default SSID "CiscoAirProvision" and the SSID that I made, so also I can't get into AP management.

How can I get rid of the Default SSID so it does not appear and can enter the GUI with the management that I have made?

I use AIR-AP1830-K9-8-8-125-0 Firmware

Re: Double Broadcast SSID

Sandeep Choudhary — Wed, 25 Sep 2019 09:50:02 GMT

reset it completely and start from scrach again.

Re: Double Broadcast SSID

Reedho — Thu, 26 Sep 2019 04:31:50 GMT

I have tried to do this. but the result still can't (same thing).

Re: Double Broadcast SSID

patoberli — Fri, 27 Sep 2019 08:43:24 GMT

Do you save the configuration before reloading it after the initial wizard?

Re: Double Broadcast SSID

Reedho — Fri, 27 Sep 2019 09:39:13 GMT

No. This is a new device, and I did a conversion from Firmware lightweight (Capwap) to Mobility Express.

for successful conversion results until I do the configuration. but after restarting, there are two SSIDs, and I can't get into device management.

Re: Double Broadcast SSID

patoberli — Fri, 27 Sep 2019 11:02:30 GMT

This is weird.
Normally (after a reset) you login to the CiscoAirProvision SSID, do the basic configuration, save and reboot. After the reboot, the old SSID should not anymore visible and your new one should be there.
Can you check with a second client if that Air... SSID is indeed broadcasted? Maybe it's a client driver fault.

Re: Double Broadcast SSID

Sandeep Choudhary — Fri, 27 Sep 2019 11:06:27 GMT

if possible, change the software version on MObility express AP and then try again.