topic 2nd interface config is in Wireless

3355 initial configuration question

srosenthal — Mon, 05 Jul 2021 07:36:17 GMT

When I am setting up the 3355 MSE I have a question about the second ethernet interface. I am not using HA. Can I assign the same IP address to the second port as I do to the first port or does it have to have a seperate address? I noticed in the Prime that when you add the MSE it only asks for one IP address.

No, you cannot assign same IP

Rasika Nayanajith — Wed, 02 Apr 2014 23:50:09 GMT

No, you cannot assign same IP address for the 2nd interface & connect to your network.

Use a single port configured in your case.

HTH

Rasika

*** Pls rate all useful responses ****

Thank you for the answer.

srosenthal — Thu, 03 Apr 2014 01:33:09 GMT

Thank you for the answer. What would I use the second port for if it is not used for HA?

Seth

2nd interface config is

Rasika Nayanajith — Thu, 03 Apr 2014 04:25:59 GMT

2nd interface config is optional, you do not want to configure it in normal scenario. Refer below

http://www.cisco.com/c/en/us/td/docs/wireless/mse/3355/user/guide/mse3355_qsg/mse_qsgmain.html

HTH

Rasika

So I have a question

c.fuller — Tue, 12 Aug 2014 19:57:19 GMT

So I have a question regarding the port configurtion.

In the autoconfiguration script there is an e0 and e1. However, on the back of the physical box there is a IMM, e1 & e2. I have configured e0 only via the script. But when I ping the default gateway it is reaching out with 1.1.1.10. Even though I have configured it with the correct IP.

I tried to move the cable to the IMM port with no success. I tried E2 with same results.

The startup config is minimal in terms of explaining what each does.

Any idea what physical port e1/2 maps to e0/e1 in the startup configuration and what should be configured and where the cable should be plugged in? No HA setup here. Just a straight IP connection into our network for communication with NCS Prime..

Regards