topic Re: Cisco PI 1.3 config multiple interfaces in Wireless

Cisco PI 1.3 config multiple interfaces

Trent Hurt — Sun, 04 Jul 2021 06:49:22 GMT

If I have a PI 1.2 system that has multiple interfaces configured I can upgrade to PI 1.3 and both interfaces remain and I can see both under the admin webpage under appliance interfaces. But if I do a fresh install of PI 1.3 I can only configure one interface. The commands fail from the cli to configure anything but gigabitethernet 0. Are multiple interfaces not supported in PI?

Re: Cisco PI 1.3 config multiple interfaces

Amjad Abdullah — Wed, 03 Apr 2013 12:04:07 GMT

You can only use Gigbitethernet0 interface. and you need to only connect port 1 on the appliance.

'''snip'''

Ethernet connectors:

Use Ethernet 1 to connect the Cisco Prime Infrastructure appliance to a network.

'''snip'''

Reference:

http://www.cisco.com/en/US/docs/net_mgmt/prime/infrastructure/1.2/install/guide/cpi_higmain.html

HTH

Amjad

Rating useful replies is more useful than saying "Thank you"

Re: Cisco PI 1.3 config multiple interfaces

Trent Hurt — Wed, 03 Apr 2013 17:28:31 GMT

I'm using a vm so no physical cables to plug in. Here is what I'm talking about... this is screenshot from a NCS that was upgraded from 1.1.1 to 1.2 then to 1.3. I could actually configure multiple interfaces and assign types to the different interfaces. Now with a fresh install of PI 1.3 I can do the commands from the cli for other interfaces besides eth0 but it fails to actually execute the commands.