topic AirCap 3602i Configuration, Workaround? in Wireless

AirCap 3602i Configuration, Workaround?

uatciscoaccount — Sun, 04 Jul 2021 06:15:09 GMT

Greetings!

I am in need of some assistance with the implimentaion of the AirCap 3602i wireless access points.

1. Is there a way to manually configure a AirCap 3602i to function without a WAN controller?

2. I have an older 4402 WAN controller that will upgrade to 7.0.235 firware, since the AIrCap 3602i requires 7.2.X firmware, is there a workaround for this?

Thank you very much for any information you may provide.

AirCap 3602i Configuration, Workaround?

rafael.samora — Wed, 19 Dec 2012 19:13:17 GMT

Hello Mark,

Look:

1 - Yes, you need check if you are using one Autonomous IOS.

2 - I check here you are right the min release 7.1.91.0 to running and I'm not sure to say if work on 7.0.235.3. I think not.

Regards.

Re: AirCap 3602i Configuration, Workaround?

George Stefanick — Wed, 19 Dec 2012 19:23:56 GMT

Mark

If you're asking does a 3600 support autonomous yes and no ..

https://supportforums.cisco.com/docs/DOC-20537

It's support for site survey ..

Hope this helps

Sent from Cisco Technical Support iPhone App

AirCap 3602i Configuration, Workaround?

Leo Laohoo — Wed, 19 Dec 2012 21:31:35 GMT

An autonomous IOS for the 1600/2600/3600 is now available. There are currently two versions of the 15.2(2). Please DO NOT use the JA version if you want to do 802.1Q trunking.

One thing good about the new 15.2(2) aIOS is the newly redesigned configuration GUI. So go ahead and check it out.

PS: You cannot run the 3600 on a 4400 controller. There is no workaround now. There is no workaround in the future. The 4400 does not have enough grunt to support the 7.1.X or 7.2.X firmware. This is one of the reasons.

AirCap 3602i Configuration, Workaround?

George Stefanick — Wed, 19 Dec 2012 21:36:34 GMT

Leo -- Is this now offically supported or still only survey mode?

__________________________________________________________________________________________
"Satisfaction does not come from knowing the solution, it comes from knowing why." - Rosalind Franklin
__________________________________________________________________________________________
‎"I'm in a serious relationship with my Wi-Fi. You could say we have a connection."

AirCap 3602i Configuration, Workaround?

Saravanan Lakshmanan — Wed, 19 Dec 2012 23:48:02 GMT

Hi George

here you go.

15.2.2JB

http://www.cisco.com/en/US/docs/wireless/access_point/ios/release/notes/15.2_2_JB.html#wp355587

Support for AP1550, AP3500E, AP3500I, AP3600E, and AP3600I,

This release provides complete software functionality to AP1550, AP3500E, AP3500I, AP3600E, and AP3600I series access points.

15.2.2JA

http://www.cisco.com/en/US/docs/wireless/access_point/ios/release/notes/15_2_2_JArn.html#wp288972

Support for Cisco Aironet 2600 Series Access Points

This release supports standalone Cisco Aironet 2600 Series Access Points. Detailed information and configuration procedures for autonomous (standalone) access point are in Chapter 6

Site-Survey Only Mode for 3600, 3500, and 1550 Access Points

You can install Cisco IOS Release 15.2(2)JA on Cisco Aironet 3600 and 3500 Series access points and on 1550 series outdoor access points to perform site surveys.

AirCap 3602i Configuration, Workaround?

George Stefanick — Wed, 19 Dec 2012 23:53:25 GMT

+5 .. When was this released ?

AirCap 3602i Configuration, Workaround?

Saravanan Lakshmanan — Wed, 19 Dec 2012 23:56:46 GMT

17-DEC-2012, couple of days ago. The gui mimic the wlc.

AirCap 3602i Configuration, Workaround?

Leo Laohoo — Thu, 20 Dec 2012 02:51:32 GMT

Hi Saravanan,

The newly released 7.4 code, does it bring the WiSM-2 base-ap-count to 1500? I can see it in "Licenses" but I can't get an answer from our SE.

AirCap 3602i Configuration, Workaround?

Saravanan Lakshmanan — Thu, 20 Dec 2012 06:06:55 GMT

Hi Leo

7.4 release notes doesn't mention about it. also i checked the other day and was told there is no change in ap support limit for wism2. please share the link that shows 1500.

also, i checked the wism2 datasheet and couldn't see 1500 unless i'm missing something.

Thanks

AirCap 3602i Configuration, Workaround?

Leo Laohoo — Thu, 20 Dec 2012 22:41:15 GMT

Hi Saravanan,

Look below.

AirCap 3602i Configuration, Workaround?

George Stefanick — Thu, 20 Dec 2012 22:52:00 GMT

Leo

I see youre still posting and its 12/21 so the world didnt end ..

Since we are on the subject of WISM2, does it create 1 or 2 chanel groups ? I plugged in the WISM 2 it shows 2 channel groups but only 1 being used ..

Re: AirCap 3602i Configuration, Workaround?

Leo Laohoo — Thu, 20 Dec 2012 23:04:19 GMT

Since we are on the subject of WISM2, does it create 1 or 2 chanel groups ? I plugged in the WISM 2 it shows 2 channel groups but only 1 being used ..

I got to distro ports since upgraded to 7.3 (if memory serves me correct). Currently, with 7.4, I've got both UP/UP.

I see youre still posting and its 12/21 so the world didnt end ..

We're ahead of the Internation Date Line. This is the Mayan Calendar so we'll know tomorrow.

Re: AirCap 3602i Configuration, Workaround?

George Stefanick — Thu, 20 Dec 2012 23:18:51 GMT

Sorry -- i dont understand ..

So you have 2 channel groups or no?

AirCap 3602i Configuration, Workaround?

Leo Laohoo — Thu, 20 Dec 2012 23:25:00 GMT

You're right. I have a single 10 Gbps etherchannel. Don't know what happened to the second link.

AirCap 3602i Configuration, Workaround?

George Stefanick — Thu, 20 Dec 2012 23:44:55 GMT

Leo -- Ask yourself, when am I ever wrong !

The odd thing is I have 2 channels.

AirCap 3602i Configuration, Workaround?

Saravanan Lakshmanan — Thu, 20 Dec 2012 23:50:48 GMT

Hi Leo

what you're seeing is a cosmetic bug. There was no change in 7.4 AP support limit.

Will open a cosmetic bug to address this, How does it happen, was it showing 1000 for base ap count before 7.4 got updated and what was the previous code.

Thanks.

AirCap 3602i Configuration, Workaround?

George Stefanick — Thu, 20 Dec 2012 23:56:23 GMT

They need to call that bug the "LEO"...

AirCap 3602i Configuration, Workaround?

Leo Laohoo — Fri, 21 Dec 2012 00:50:51 GMT

Leo -- Ask yourself, when am I ever wrong !

LOL!

The odd thing is I have 2 channels.

Same here.

Re: AirCap 3602i Configuration, Workaround?

George Stefanick — Fri, 21 Dec 2012 02:25:05 GMT

So u have 2 channels ?

Sent from Cisco Technical Support iPhone App