topic Suppressing - %DOT11-4-MAXRETRIES in Wireless

Suppressing - %DOT11-4-MAXRETRIES

nikalleyne — Sun, 04 Jul 2021 03:22:03 GMT

Morning Guys,

I have a couple of Aironet APs.

Syslog logging level is 6 - Informational.

Is there a way I can suppress these messages "<188>3774: Jun 27 22:55:46.520: %DOT11-4-MAXRETRIES: Packet to client xxxx.xxxx.xxxx reached max retries, removing the client" from being sent to my Syslog?

Thanks

Suppressing - %DOT11-4-MAXRETRIES

Surendra BG — Tue, 28 Jun 2011 15:22:37 GMT

This means its RF related issues (Interference).. here is the link that tells the same..

http://www.cisco.com/en/US/products/hw/wireless/ps430/products_tech_note09186a008024aa4f.shtml

http://www.cisco.com/en/US/docs/wireless/access_point/12.3_7_JA/configuration/guide/s37err.html

Lemme know if this answered ur question and please dont forget to rate the usefull posts that answered ur question!!

Regards

Surendra

Suppressing - %DOT11-4-MAXRETRIES

nikalleyne — Tue, 28 Jun 2011 16:55:27 GMT

Hey Surendra,

Thanks for the quick and prompt response. However, I was hoping for a command that disables such notification.

eg . no .....

Is there such a command or do I have to just live with these messages?

Suppressing - %DOT11-4-MAXRETRIES

Surendra BG — Tue, 28 Jun 2011 16:58:27 GMT

Hi,

term no mon

conf t

no logging console

exit

This will do it for you in popping up the msgs.. but the logs will have a copy though!!

lemme know if this answered ur question and please dont forget to rate the usefull posts!!

Regards

Surendra

Suppressing - %DOT11-4-MAXRETRIES

Nicolas Darchis — Tue, 28 Jun 2011 17:00:31 GMT

You can also raise the logging level to only show informational but then you are missing other messages too. Not very granular ...

Suppressing - %DOT11-4-MAXRETRIES

nikalleyne — Tue, 28 Jun 2011 17:14:20 GMT

I'm not worried about the messages popping up at the console, so at the console, logging is at debug.

However, for the Sylog it's already at informational.

Surendra,

Your solution also does not address the issue as this basically turns off logging for the console and I'm more concerned about messages going to my SysLog server.

Can this message be turned off like for example, if I don't wish to have link status logging when a link goes up or down on a switch i can say

config t

int fa0/0

no logging event link-status

can I do something similar with these messages?