topic Re: Primary/secondary RADIUS server in Wireless

Primary/secondary RADIUS server

jeff.kish — Sat, 03 Jul 2021 23:27:50 GMT

Hey all,

I've been trying to discover for a while how primary and secondary RADIUS servers work on WLC 4400s. If the primary RADIUS server goes down, and the secondary is used, at what point does the controller go back to the primary once it's back up? Does it wait until the secondary goes down, or does it immediately switch back to the primary once it becomes available?

Thanks in advance!

Jeff

Re: Primary/secondary RADIUS server

Scott Fella — Thu, 11 Sep 2008 16:25:30 GMT

On 4.2 and previous versions, if the primary goes down, then the secondary is used until the secondary is not available. So if you want to froce the primay to be the radius server to be used, reboot the secondary. Then the tertiary then back to the primary. 5.0 has a feature in which you can set a keep alive so that when the primary comes back up, the primary will be used again. 5.0 code in not a good code version though.

Re: Primary/secondary RADIUS server

jeff.kish — Thu, 11 Sep 2008 17:57:49 GMT

I seem to hear a lot about how bad 5.0 code is. Either way, that definitely helps a lot. Thanks!

Re: Primary/secondary RADIUS server

Robert Rowland III — Thu, 11 Sep 2008 20:03:50 GMT

5.1 is out for a month.

I have 700 radios on it. No problems so far and it has corrected issues I saw with 5.0.

Especially with voice.

Re: Primary/secondary RADIUS server

Scott Fella — Thu, 11 Sep 2008 20:14:50 GMT

That is good to know.... we are still testing that code. What are you running 5.1 on? WiSM's and type of AP's?