topic Re: WLSE: Initial console port configuration in Wireless

WLSE: Initial console port configuration

colin.lynch — Sun, 04 Jul 2021 17:35:06 GMT

Hi Hopfully not to dumb a question:

I am doing an Install and have a WLSE 1130 and I can not get any connection to the console to do the initial setup.

I have tried 96,8,1,n and 115200,8,1,n

I have been config'ing the ACS engine fine so I know my console is OK.

I just get a flashing green LED on the front, no network LED although it is connected.

Is it somthing stupid I'm doing, or is my WLSE DOA.

Regards

Colin

Re: WLSE: Initial console port configuration

colin.lynch — Mon, 21 Mar 2005 17:09:36 GMT

Don't worry, I found somthing called "the on button"

I'll go and commit ritual suicide.

At least it's yopu guys thinking I'm a pleb and not TAC. 🙂

Shamfully

John Smith

Re: WLSE: Initial console port configuration

rmushtaq — Mon, 21 Mar 2005 17:14:42 GMT

Use Windows Hyper Terminal. Setting need to be baud=9600 and the rest should be default. Make sure that you connect to the serial port located at the back of the WLSE.