https://community.cisco.com/t5/wireless/cli-command-to-view-master-controller-config-state/m-p/4184565#M223245 <P>Run the command:&nbsp;</P> <P>&nbsp;</P> <P><STRONG>show network summary</STRONG></P> <P>&nbsp;</P> <P>and then search for Cisco AP Default master : It will be either Enable or disable&nbsp;</P> <P>&nbsp;</P> <P>Regards</P> <P>Dont forget to rate helpful posts</P> Tue, 17 Nov 2020 07:39:35 GMT Sandeep Choudhary 2020-11-17T07:39:35Z https://community.cisco.com/t5/wireless/cli-command-to-view-master-controller-config-state/m-p/4184560#M223244 <P>Is anyone aware of a way I can quickly check the <STRONG id="ID345__ID350" class="ph b B_Bold-7204837A">Controller</STRONG><SPAN>&nbsp;&gt;&nbsp;</SPAN><STRONG id="ID345__ID351" class="ph b B_Bold-7204837A">Advanced</STRONG><SPAN>&nbsp;&gt;&nbsp;</SPAN><STRONG id="ID345__ID352" class="ph b B_Bold-7204837A">Master Controller Mode</STRONG>&nbsp;enabled/disabled state from the CLI.&nbsp;<SPAN style="font-family: inherit;">I am aware I can configure it with&nbsp;<STRONG>config network master-base [enable|disable]&nbsp;</STRONG>however I'm having issues identifying this outside of the GUI.&nbsp;<BR /></SPAN></P> Mon, 05 Jul 2021 19:47:43 GMT https://community.cisco.com/t5/wireless/cli-command-to-view-master-controller-config-state/m-p/4184560#M223244 Damien Miller 2021-07-05T19:47:43Z https://community.cisco.com/t5/wireless/cli-command-to-view-master-controller-config-state/m-p/4184565#M223245 <P>Run the command:&nbsp;</P> <P>&nbsp;</P> <P><STRONG>show network summary</STRONG></P> <P>&nbsp;</P> <P>and then search for Cisco AP Default master : It will be either Enable or disable&nbsp;</P> <P>&nbsp;</P> <P>Regards</P> <P>Dont forget to rate helpful posts</P> Tue, 17 Nov 2020 07:39:35 GMT https://community.cisco.com/t5/wireless/cli-command-to-view-master-controller-config-state/m-p/4184565#M223245 Sandeep Choudhary 2020-11-17T07:39:35Z