topic Re: C9130AX-B question in Wireless

C9130AX-B question

Vic.Gonz — Tue, 20 Jul 2021 16:41:52 GMT

I need to know how to format everything on a C9130AX-B to remove all files and data. Not looking to do a standard factory reset but to remove everything.

Re: C9130AX-B question

balaji.bandi — Tue, 20 Jul 2021 16:45:16 GMT

what files you looking to remove, how is this AP managing using WLC ? or WG mode ?

Re: C9130AX-B question

Vic.Gonz — Tue, 20 Jul 2021 17:01:10 GMT

ll files need to be removed him not sure which mode, and that i'm thinking might be easier to do it from the (BTLDR) # using one of the erase commands but everything needs to be erase.

Re: C9130AX-B question

Leo Laohoo — Wed, 21 Jul 2021 00:09:21 GMT

capwap ap erase all

Re: C9130AX-B question

balaji.bandi — Wed, 21 Jul 2021 11:25:29 GMT

Look at the below document give you some information to erase :

https://www.cisco.com/c/en/us/support/docs/wireless/aironet-1200-series/99763-reset-lwappconfig-lap.html

Re: C9130AX-B question

00u1ab28axbOOzhqE5d7 — Wed, 21 Jul 2021 12:58:32 GMT

I need to erase/format everything including the OS, flash, partitions, M.2 storage (everything) and enter a command to show all of the devices etc do not have any files/items left on them. I need to essentially make this thing a brick and show that it is a brick. I'm thinking the best way to do this might be from the btldr prompt. It was a lot easier with the other rommon operating system you just had to format flash and that wiped everything out. These have a more complex btldr and cli and that is not very intuitive. Not only do i now know how to format/erase all devices and partition but i also done know how the command to show the devices/partitions dont have any files on them for documentation. Thanks in advance for any assistance.

Re: C9130AX-B question

Leo Laohoo — Wed, 21 Jul 2021 22:28:57 GMT

Pop the lid open and smash the printed circuit board with a sledgehammer (or get a steam roller).