topic Minor Alret at prime infrastructure 2.0 about mismatch configura in Wireless

Minor Alret at prime infrastructure 2.0 about mismatch configuration.

Ahmed Ayaad — Sun, 04 Jul 2021 08:20:33 GMT

Dears,

kindly i have minor Alert at prime infrastructure 2.0 (Audit done at '2013-nov-28,05:00:00 CET'..config difference found between NCS and Controller),

what this error and please feed me back with steps to solve this problem.

Thanks,

Re: Minor Alret at prime infrastructure 2.0 about mismatch confi

Scott Fella — Thu, 28 Nov 2013 15:51:45 GMT

The WLC and PI don't sync... So if you make a change to your WLC, eventually when PI pills the WLC, there will be a mismatch. To clear the mismatch, you just need to refresh the configuration from the WLC on PI.

Sent from Cisco Technical Support iPhone App

Minor Alret at prime infrastructure 2.0 about mismatch configura

Ahmed Ayaad — Thu, 28 Nov 2013 15:56:17 GMT

Thanks Scott can you advice with steps

Re: Minor Alret at prime infrastructure 2.0 about mismatch confi

Sandeep Choudhary — Thu, 28 Nov 2013 17:12:34 GMT

Hi Ahmed,

adding to Scott:

First check your theme(Classic or Lifecycle).......Go to Root and see the Theme.

There are steps for classic theme

Go to Configure> Controllers

and then which controller have config mismatch...on right side click on mismatch in Audit status tab.

After that it will ask for audit now, click on that. After auditing it will show you the two option:

1. Restore PI values to Controller

2. Refresh config from controler

Clcik on 2nd #Refresh config from controler#

Then select 2nd option again(Use the configuration on the controller currently) and click on GO.

Regards

Dont forget to rate helpful posts

Re: Minor Alret at prime infrastructure 2.0 about mismatch confi

Ahmed Ayaad — Thu, 28 Nov 2013 18:40:32 GMT

thanks i will try and feed back you, but please can you tell me if i choose #Refresh config from controler# this is will need down time or not.

Minor Alret at prime infrastructure 2.0 about mismatch configura

Sandeep Choudhary — Thu, 28 Nov 2013 19:37:53 GMT

HI Ahmed,

No need.....for downtime.

It will just updated the config on PI from controller.

Regards

Dont forget to rate helpful posts

Cool!this two year old post

wirelessman — Wed, 29 Jul 2015 07:20:08 GMT

Cool!

this two year old post solved my current "config difference found between NCS and Controller" problem.

Thanks, Sandeep!

Hi Sandeep,

Navneet Panwar — Thu, 18 Feb 2016 03:59:58 GMT

Hi Sandeep,

Thanks for your support, I am getting same message and now it is resolved.