topic Re: WLC 9800 Syslog in Wireless

WLC 9800 Syslog

OJ_Magellan — Tue, 21 Sep 2021 11:34:30 GMT

I want to configure WLC 9800 to send Syslog messages to an external Syslog server. In the configuration I can only see the configurations for the IP address and vrf, how about the protocol and port number? what does the WLC uses? UDP 514?

Regards,

Re: WLC 9800 Syslog

Arshad Safrulla — Tue, 21 Sep 2021 12:58:14 GMT

Yes default is udp 514, You can set this on CLI

loggin host <IP Address> transport <TCP/UDP> port <PortNumber>

Re: WLC 9800 Syslog

OJ_Magellan — Wed, 22 Sep 2021 08:05:07 GMT

so only through the CLI the Port and Protocol are adjustable? cause through the GUI its not possible.

Re: WLC 9800 Syslog

Sandeep Choudhary — Wed, 22 Sep 2021 08:27:02 GMT

No, at the moment via GUI is not possible. May be in future cisco may update these setting in GUI as well.

Regards

Dont forget to rate helpful posts

Re: WLC 9800 Syslog

OJ_Magellan — Fri, 24 Sep 2021 10:34:01 GMT

Since the WLC is connected to the DNAC, is it possible to configure l"oggin host <IP Address> transport tls port <PortNumber>" through the DNAC or the only possible way is the WLC's CLI?

Regards,