topic WCS not graphing CleanAir Interferers in Wireless

WCS not graphing CleanAir Interferers

jlhainy — Sun, 04 Jul 2021 03:25:48 GMT

I have WCS managing 4 controllers. 1 of which has clean air enabled. WCS gives air quality reports just fine, but it gives me no information on the Device Interferers or the Interferer count. I can go to the controller, go to monitor>cleanair and look at the APs that find interferers and then graph the data to show bluetooth, microwaves, continuous transmitters etc, but why is this info not seen in WCS?

WCS not graphing CleanAir Interferers

Nicolas Darchis — Tue, 12 Jul 2011 06:25:11 GMT

You need a PLUS license on WCS and you also need a synchronized MSE for WCS to display the interferers because they will be merged by the MSE.

WCS not graphing CleanAir Interferers

jlhainy — Tue, 12 Jul 2011 22:45:18 GMT

I have the Plus location license, what I don't have is the MSE. So you are saying I need to have the MSE for it to graph the interferers data. I am not trying to to see them on the map, but on the clean air tab, there are various graphs. I figured that the interferes graph would just show a grapch of the types of interferers like Microwaves and bluetooth devices, like the WLC does. Is this not the case?

WCS not graphing CleanAir Interferers

Nicolas Darchis — Wed, 13 Jul 2011 05:56:32 GMT

From WCS config guide :

The information in the worst interferer and interferer count charts is collected from Mobility Services Engines (MSE). If MSEs are not available, this chart will not show any results."

http://www.cisco.com/en/US/docs/wireless/wcs/7.0MR1/configuration/guide/wst.html#wp1168776

WCS not graphing CleanAir Interferers

jlhainy — Mon, 18 Jul 2011 16:57:35 GMT

Awesome, that is what I was looking for.

Thanks.

WCS not graphing CleanAir Interferers

Vinay Sharma — Tue, 19 Jul 2011 10:29:19 GMT

Thanks Nicolas for information on mobility service engine (MSE).

Vinay Sharma

COmmunity Manager - Wireless

WCS not graphing CleanAir Interferers

ch.koeber — Tue, 13 Dec 2011 10:32:32 GMT

Hi,

one needs for the Air Quality graph in the WCS also a Mobility Services Engine appliance?

These values are in my WCS 7.0.172.0 PLUS will not also be shown.

Thanks an regards.