Calibration error message in WCS(MSE)

ajmadriaga — Sun, 04 Jul 2021 03:05:05 GMT

I get a calibration error message in WCS when I try to add data points in the RF calibrate models section. Here is the error message:

Error in Calibration. MessageMEDIATION-5, WcCalibration!x.x.x.x!xx:xx:xx:xx:xx:xx,row Status,No access

The first set of x is the IP address of the controller and the other x is the MAC address of the wireless system that is being used for calibration.

Re: Calibration error message in WCS(MSE)

Frederik Schon — Thu, 21 Apr 2011 13:02:32 GMT

Hi,

Which Wireless-Card you used?

Best you use the Cisco CB21AG PCMCIA Card. I had similar problems with intel wireless chipsets

Sincerely,

Frederik