topic Re: AIR-CAP702I-E-K9 in Wireless

AIR-CAP702I-E-K9

Ziad Mohsen — Sun, 28 Nov 2021 19:28:15 GMT

hello,

the ssid is hidden on my AP AIR-CAP702I-E-K9, can any one tell me how to make it visible.

thank you

Haydn Andrews — Sun, 28 Nov 2021 22:04:41 GMT

If the AP is being managed from a controller.

WLANs tick the box broadcast SSID enabled.

If you have an autonomous mode AP then:

you need command:

mbssid guest-mode - if you have multiple SSIDs or ssid guest-mode in the dot11 ssid config part

Ziad Mohsen — Mon, 29 Nov 2021 07:21:19 GMT

can you please help me further i'm still new to cisco APs, and i done't have a controller, can you tell me where to put the commaned

also i have attached screen shots to my ssid manager page if it well help.

Sandeep Choudhary — Mon, 29 Nov 2021 09:41:06 GMT

Hi,

If you are single ssid on AP then do these:

Conf ter
Dot11 ssid <SSID name>
Guest-mode

Regards

Dont forget to rate helpful posts

Haydn Andrews — Mon, 29 Nov 2021 22:58:26 GMT

If its only a single SSID your trying to do.

On Capture 4.

Where it says Set Single Guest Mode SSID and the drop down box is <None> change that to your SSID

otherwise on capture 3. Under multiple BSSID Beacon Settings:

Tick Set SSID as Guest Mode then in capture 4 for the set beacon select Multiple BSSID.