topic Re: I accidentally added an interface to the wrong interface group on in Wireless

I accidentally added an interface to the wrong interface group on 5508

bjohnson04 — Thu, 16 Jun 2022 18:39:40 GMT

I accidentally added an interface to the wrong interface group

Interface abc to our guest interface group. I tried disabling the abc WLAN and then removing it from the group but that didnt work. Im still get the error "Interface group is being used by WLAN"

What do I need to do to remove this interface?

Re: I accidentally added an interface to the wrong interface group on

Rasika Nayanajith — Thu, 16 Jun 2022 18:49:49 GMT

Temporary map different interface to WLAN (under AP group & global WLAN config) & then go under interface group & remove the unwanted interface. Then you can remap the interface group to the WLAN

HTH

Rasika

*** Pls rate all useful responses ***

Re: I accidentally added an interface to the wrong interface group on

Flavio Miranda — Thu, 16 Jun 2022 18:57:05 GMT

Hopefully you dont have this interface group added to many AP group . I did the same mistake already and I had the interface group in about 100 AP groups. I had to use a spreadsheet to run all AP group deleting and interface group. Then taking off on interface and adding the interface group back in all AP groups again.

Re: I accidentally added an interface to the wrong interface group on

magNHS — Fri, 24 Nov 2023 16:43:15 GMT

Hi @Rasika Nayanajith

What is the impact of perform the suggested action?

I assuming that this will lead to WLAN being unavailable while the interface group is remapped causing outage!

Re: I accidentally added an interface to the wrong interface group on

Rich R — Fri, 24 Nov 2023 17:53:34 GMT

Yes obviously so should be done during a maintenance window @magNHS